Journal of the American Ceramic Society

Papers
(The H4-Index of Journal of the American Ceramic Society is 36. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-01-01 to 2026-01-01.)
ArticleCitations
Evaluation of crack initiation load of silica glass surfaces formed during subcritical crack growth126
Stabilization of thermal storage ceramics via the phase reconstruction of ferrotitanium slag and migration of Mg element95
Degradation of alkali‐activated Fe‐rich slag in magnesium sulfate solution85
Conversion of borate glass microspheres to hollow biphasic calcium phosphate ceramic microspheres for bone defects79
Robust room‐temperature ferroelectricity and magnetoelectric coupling effect in epitaxial CaTiO 3 /SmFeO 3 73
Photoelectrochemical properties of butane reduced flame‐treated Zr‐doped hematite thin films71
Issue Information68
Fabrication and mechanical properties of metakaolin‐based geopolymer composites reinforced with auxetic fabrics68
Influence of point defect concentration on the generalized stacking‐fault energy in uranium dioxide67
A super broad emission band in tri‐doped orthosilicate phosphors for full‐spectrum white light illumination64
Electret‐induced antibacterial response of Mg 1‐ x Ca 54
Correction to: Fe 3 O 4 /C@SiC nanocomposite microwave aborbing material derived from MIL‐101(Fe)@51
Thermo‐rheological snapshot of melter feed conversion to glass50
Improvement of piezoelectric properties of PZT‐based low‐temperature‐sintered ceramics through heterovalent ion doping47
A facile route for decoration of hematite photoanodes by transition metal hydroxide co‐catalysts47
Rapid microwave sintering of centimetric zirconia: Scalability and electromagnetic‐thermal‐fluid‐dynamic simulation45
Issue Information44
Electromechanical properties of paper‐derived potassium sodium niobate piezoelectric ceramics43
Optimized ablation resistance behavior and mechanism of C/SiC composites with high thermal conductive channels43
Adsorption of anionic polyelectrolyte on an SiC surface and effects on dispersion stability42
Energy materials and systems division (EMSD) special issue41
Prevention of SiC‐fiber decomposition via integration of a buffer layer in ZrB 2 ‐based ultra‐high temperature ceramics41
Synergistic modification of properties in Ba[(Zn 0.8 Mg 0.2 ) 1/3 41
Oxidation kinetics of silicon carbide‐containing refractory diborides, I: Revised model41
Enhancing the mechanical properties of ceramics by high‐temperature rolling: A first demonstration using alumina41
High‐entropy effect on the electrical properties and aging stability of lanthanum aluminate ceramics40
Atomistic simulations of water‐driven structural and mechanical changes in N–A–S–H gels40
Outstanding pure green upconversion luminescence in LaZrTa 3 O 11 :Er 3+<39
CdCu3Ti3MnO12−δ quadruple perovskites: High‐pressure synthesis, structural, magnetic, and dielectric properties39
High‐temperature oxidation behavior of the SiC layer of TRISO particles in low‐pressure oxygen39
Steam oxidation and microstructural evolution of rare earth silicate environmental barrier coatings39
Synthesis of novel multi‐anion Hf0.8Zr0.2B0.1C0.5N0.4 powder39
Six‐principal‐component high‐entropy IVB–VB diborides: Low‐temperature synthesis, microwave absorption, and mechanisms38
Effect of sintering temperature on the dielectric properties of 3D‐printed alumina (Al 2 O 3 ) in 37
Effect of BaO on viscosity and structure of B 2 O 3 –SiO 2 37
Microstructural and infiltration properties of woven preforms during chemical vapor infiltration36
Pressure‐induced phase changes in polycrystalline Y 2 O 3 : Influence on structure and properties36
0.40957689285278