OOIR: Observatory of International Research

Papers

(The TQCC of Journal of Applied Mechanics and Technical Physics is 2. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-01-01 to 2026-01-01.)

Article	Citations
Generative Adversarial Neural Networks for the Heuristic Modelling of a Two-Phase Flow in Porous Media	15
Coupled Numerical Model of Creeping Multiphase Flow	12
ULTRASONIC AND METALLOGRAPHIC STUDY OF THE HEAT-AFFECTED ZONE OF A CARBON STEEL WELDED JOINT UNDER PLASTIC DEFORMATION AND FATIGUE	8
ROBUST SUPER-TWISTING HIGH-ORDER SLIDING MODE CONTROLLER FOR A DUAL-AXIS SOLAR TRACKER TO ACCURATELY TRACK THE SUN TRAJECTORY	7
SOLUTION OF A MULTIPLE CRACK PROBLEM UNDER THE INFLUENCE OF A LINEAR STRESS DISTRIBUTION AND COALESCED YIELD ZONES	7
TEMPERATURE DYNAMICS IN A WELL DURING LOCAL INDUCTION HEATING OF THE WELL CASING	7
ENERGY APPROACH TO ESTIMATING THE QUALITY OF THE SPRAY GENERATED BY A MODEL PNEUMATIC ATOMIZER	7
VISCOELASTIC PROPERTIES OF SILICONE RUBBER WITH ADDITION OF CARBON NANOTUBES	6
WETTING OF LIQUID DROPLETS ON TWO PARALLEL FIBERS WITH DIFFERENT RADII	6
Spreading of a Layer on a Rotating Plane in an Aqueous Solution of a Polymer	5
Vector Field Characteristics Related to Aminov’s Divergent Representations and Conservation Laws	5
NUMERICAL SIMULATION AND EXPERIMENTAL RESEARCH OF CR–AG COATINGS FOR THE ITER SCC THERMAL SHIELD	5
NUMERICAL SIMULATION STUDY OF THE FLUID–STRUCTURE INTERACTION OF THE ARTERY UNDER PERIODIC EXTERNAL FORCING OF MASSAGE	5
EXPERIMENTAL AND ANALYTICAL STUDY OF GEOMETRIC NONLINEAR BENDING OF A CANTILEVER BEAM UNDER A TRANSVERSE LOAD	5
Numerical Study of the 2D Cahn–Hilliard Model of Phase Separation with Logarithmic Potential	5
INFLUENCE OF AN EXTERNAL TANGENTIAL ELECTRIC FIELD ON THE DEVELOPMENT OF CAPILLARY TURBULENCE OF THE FREE SURFACE OF A NON-CONDUCTING FLUID	5
QUASIBRITLE FRACTURE OF SMOOTH SHAFTS UNDER TORSION	5
SURFACE CONSTANT-TEMPERATURE ANEMOMETER SENSORS USED TO ANALYZE PARTICLE IMAGE VELOCIMETRY DATA	5
KELVIN–VOIGT IMPULSIVE EQUATIONS OF INCOMPRESSIBLE VISCOELASTIC FLUID DYNAMICS	5
NUMERICAL CALCULATION OF THE HYDRODYNAMIC CHARACTERISTICS AND STRUCTURAL RESPONSE OF A SUPERSONIC TRUNCATED CONICAL PROJECTILE ENTERING WATER	5
Turbulent Flow Structure in a Hemicylindrical Dimple on the Wall of a Flat Channel	5
INFLUENCE OF SINUSOIDAL PERTURBATIONS IN THE DISPERSED PHASE FLOW RATE ON THE FLOW CHARACTERISTICS OF IMMISCIBLE VISCOUS LIQUIDS IN A T-JUNCTION MICROCHANNEL	4
REFINED MODEL OF DYNAMIC DEFORMATION OF A FLAT ROD WITH A FINITE-LENGTH FIXED REGION ON AN OUTER SURFACE	4
ELASTOPLASTIC FRACTURE OF A PLATE WITH TWO EDGE CRACKS	4
INVESTIGATION OF THE THERMAL STRESSED STATE OF A HYDROGEN RECOVERY REACTOR	4

EFFECT OF HIGH-TEMPERATURE TREATMENT OF BRONZE PARTICLES ON THE CHARACTERISTICS OF COATINGS FORMED BY THE METHOD OF COLD SPRAYING	4
OPTICAL AND GAS-DYNAMIC MEASUREMENTS IN A MICROWAVE DISCHARGE PLASMA FLOW UNDER CONDITIONS OF GAS-JET SYNTHESIS OF DIAMOND	4
Effect of the Slot Orientation Angle on Stabilization of a Supersonic Boundary Layer	4
ANALYZING A BIMORPH PIEZOELECTRIC NANOSCALE ACTUATOR UNDER PRIMARY-RESONANCE EXCITATION	4
FREE VIBRATION ANALYSIS OF A BIDIRECTIONAL FUNCTIONALLY GRADED CARBON NANOTUBE REINFORCED COMPOSITE BEAM	4
SOLUTION OF THE PROBLEM OF COMPRESSION OF A TWO-LAYER NONLINEAR MATERIAL	4
DEPENDENCE OF THE BUBBLE VELOCITY IN AN INCLINED FLAT CHANNEL ON THE GAS VOLUME FRACTION AND BUBBLE DIAMETER	4
PHYSICOMATHEMATICAL MODELING OF HUMAN BREATHING IN SITUATIONS OF VARIOUS PULMONARY DISEASES	4
RECENT TRENDS IN LASER WELDING AND ADDITIVE TECHNOLOGIES (REVIEW)	4
Mechanical Characteristics of an Explosive in the Temperature Range 20–100°C	3
INFLUENCE OF THE BOUNDARY THERMAL REGIME ON CHARACTERISTICS OF BILAYER FLOWS UNDER DIFFUSIVE EVAPORATION	3
INFLUENCE OF SiC CERAMIC FIBER IN A METAL MATRIX COMPOUND ON ITS RESISTANCE UNDER HIGH-RATE LOADING	3
INTERNAL WAVES IN TWO-LAYER STRATIFIED FLOWS	3
SIMILARITY PARAMETER FOR THE DRAG COEFFICIENT OF A CYLINDER WITH A HIGH-POROSITY FRONTAL INSERT ALIGNED AT AN ANGLE OF ATTACK IN A SUPERSONIC FLOW	3
ENHANCING VISCOUS OIL RECOVERY IN THE MICROBUBBLE FILTRATION MODE USING SUPERCRITICAL FLUID SYSTEMS	3
NONLINEAR DEFORMATION AND STABILITY OF A COMPOSITE CYLINDRICAL SHELL UNDER COMBINED LOADING BY TORQUE, BENDING MOMENT, AND INTERNAL PRESSURE	3
Interaction of Shock Waves with Gas-Permeable Cellular Porous Materials	3
EFFECT OF LASER SURFACE REMELTING OF 304 STAINLESS STEEL	3
COUPLED FRACTURE MODEL OF ELASTOPLASTIC MATERIALS BASED ON A KINETIC EQUATION OF DAMAGE ACCUMULATION AND THE PISARENKO–LEBEDEV STRENGTH CRITERION	3
LOCALIZED FORCING OF THE TWO-DIMENSIONAL BOUNDARY LAYER BY INDIVIDUAL MICRODISCHARGES IN A PLASMA ACTUATOR	3
EFFECT OF MOLDING PRESSURE ON CHARACTERISTICS OF RADIOPROTECTIVE COMPOSITES	3
DRAG COEFFICIENT OF A CYLINDER WITH A FLAT PLATE PLACED BEHIND IT	3
DYNAMICS OF FORMATION AND RADIATION OF A CYLINDRICAL CAVITY IN A CAVITATING FLUID	3
AERODYNAMIC FEATURES OF A ROTATING CYLINDER WITH A DEFLECTOR	3
NORMAL COORDINATE METHOD FOR STUDYING FORCED OSCILLATIONS OF DISSIPATIVE SYSTEMS IN MECHANICS AND ELECTRICAL ENGINEERING	3
TWO-LAYER STEADY CREEPING THERMOCAPILLARY FLOW IN A THREE-DIMENSIONAL CHANNEL	3
SILICON SURFACE PATTERNING BY GLOW DISCHARGE PLASMA	3
ESTIMATION OF RESERVOIR PROPERTIES TAKING INTO ACCOUNT OIL DEGASSING IN THE BOTTOM-HOLE ZONE	3
MODELING OF CRYSTALLIZATION IN A METAL SURFACE LAYER MODIFIED WITH NANOPARTICLES UNDER PULSED INDUCTION HEATING	3
EFFECT OF INTERNAL PYLONS ON THE PARAMETERS OF THE JET FLOW IN A NOZZLE WITH A CENTRAL BODY	3
PROPAGATION OF OBLIQUE FLEXURAL GRAVITY WAVES OVER FINITE NUMBER OF STEPS	3
SHOT-PEENING-INDUCED RESIDUAL STRESSES IN POWDER COATINGS PRODUCED BY SPRAYING	3
SMALL ICING WIND TUNNEL BASED AT THE KHRISTIANOVICH INSTITUTE OF THEORETICAL AND APPLIED MECHANICS OF THE SIBERIAN BRANCH OF THE RUSSIAN ACADEMY OF SCIENCES	3
INFLUENCE OF THE INITIAL ROUGHNESS OF INTERFACES ON THE INSTABILITY DEVELOPMENT AFTER SHOCK-WAVE PASSAGE	3
FLIGHT ASYMMETRY OF MAGNETICALLY DRIVEN FLAT LINERS	2
DESIGNING A NEW EXPERIMENTAL SYSTEM FOR STUDYING SLIDING ON SNOW	2
MATHEMATICAL MODEL OF HEMODYNAMIC RESTRUCTURING IN THE ENVIRONMENT OF A VASCULAR MALFORMATION DURING NEUROSURGICAL INTERVENTION	2
FINITE ELEMENT MODELING AND OPTIMIZATION OF THE LUMBAR INTERBODY CAGE BASED ON THE ADDITIVE MANUFACTURING METHOD	2
Arrhenius Activation Energy and Zero Nanoparticles Flux Effects on Free Convection Flow of a Nanofluid Past an Isothermal Elliptical Cylinder with Internal Heat Generation	2
DETERMINATION OF THE EFFECTIVE DYNAMIC YIELD STRENGTH OF HETEROGENEOUS MATERIALS	2
HIGH-PRECISION VOLUMETRIC POWDER FEEDER	2
GENERATION OF STREAMWISE STRUCTURES BY EXTERNAL VORTICAL AND THERMAL WAVES	2
INVESTIGATION OF NONLINEAR DEFORMATION AND STABILITY OF A COMPOSITE SHELL UNDER PURE BENDING AND INTERNAL PRESSURE	2
DIFFUSION WAVE INITIATION PROBLEM FOR A NONLINEAR PARABOLIC SYSTEM IN THE CASES OF SPHERICAL AND CYLINDRICAL SYMMETRY	2
TURBULENT STRUCTURE IN A FREE BUBBLY JET: AN ANALYSIS OF HIGHER-ORDER STATISTICAL MOMENTS OF VELOCITY FLUCTUATIONS	2
TORSION OF A TWO-LAYER ELASTIC ROD WITH A BOX SECTION	2
EXPERIMENTAL AND THEORETICAL STUDY OF THE JET FORMED BY MEANS OF SPUTTERING OF ELECTRODES IN AN ARC DISCHARGE	2
EFFECT OF WALL HEATING ON THE CHARACTERISTICS OF NEAR-WALL REVERSE FLOW EVENTS OCCURRING IN A TURBULENT DUCT	2
MECHANICAL PROPERTIES OF SALMONELLA TYPHIMURIUM AND LISTERIA MONOCYTOGENES BACTERIA	2
SPECIFIC FEATURES OF FLAME FORMATION IN A COLLISION OF TWO HYDROGEN JETS	2

Nonlocal Solution to the Heat Conducton Problem for a Rod	2
EXPERIMENTAL STUDY OF EVOLUTION OF CONTROLLED PERTURBATIONS IN A LONGITUDINAL VORTEX GENERATED IN A BOUNDARY LAYER ON A FLAT PLATE AT A MACH NUMBER M = 2	2
THERMAL BOUNDARY EFFECT ON THE HEAT TRANSFER PERFORMANCE OF A RIBBED COOLING CHANNEL WITH INTERSECTING RIBS	2
MODELING OF BOTTOM-HOLE PRESSURE DYNAMICS IN A SLANTED WELL	2
ON THE THEORY OF SLOPE FLOWS OVER A THERMALLY INHOMOGENEOUS SURFACE	2
RESPONSE OF A MICROHEATER–SOLUTION SYSTEM WITH A LOWER CRITICAL SOLUTION TEMPERATURE UNDER A POWERFUL LOCAL HEAT IMPACT. EXPERIMENTAL METHODOLOGY	2
RECONSTRUCTION OF TRANSONIC FLOW PARAMETERS IN THE CONE WAKE	2
EFFECT OF LASER IMPACT PARAMETERS ON THE FORMATION OF A POOL OF THE MOLTEN B4C — Ti–6Al–4V CERMET MIXTURE	2
ASYMPTOTIC MODEL OF A PIEZOELECTRIC COMPOSITE BEAM	2
SUPERSONIC GAS FLOW FROM AN ANNULAR NOZZLE INTO A LOW-PRESSURE CHAMBER WITH AN AXIAL CHANNEL: KINETIC AND CONTINUUM SOLUTIONS	2
INFLUENCE OF BOTTOM IRREGULARITY ON SOLITARY-WAVE INTERACTION WITH A PARTIALLY IMMERSED RECTANGULAR BODY	2
FLUID FILTRATION IN RESERVOIRS SUBJECTED TO HYDRAULIC FRACTURING DURING TRANSIENT WELL OPERATION	2
CALCULATION OF STRESS-STRAIN STATE OF FIBER COMPOSITE ADHESIVE	2
GAS DYNAMICS AND LIQUID FUEL COMBUSTION IN A MODEL COMBUSTOR	2
LOCAL EQUILIBRIUM APPROXIMATION IN THE MATHEMATICAL MODEL OF THE FAR TURBULENT WAKE BEHIND A BODY OF REVOLUTION	2
SPIRAL HIGH-VOLTAGE PULSE GENERATOR WITH SPATIALLY SEPARATED INDUCTIVE AND CAPACITIVE PARTS	2
INVESTIGATION OF THE INFLUENCE OF DISTRIBUTED PROPULSION ON THE STRUCTURE OF A SEPARATED FLOW AROUND A TRAPEZOIDAL MODEL OF A FLYING WING	2
SEARCH FOR STATIONARY POISEUILLE FLOWS FOR AN INCOMPRESSIBLE POLYMER FLUID IN CHANNELS WITH PERFORATED WALLS	2
BALLISTIC LIMIT OF A THIN PLATE INTERACTING WITH A COMPOUND PROJECTILE	2
LONG-WAVE FLEXURAL VIBRATIONS AND DEFORMATION OF A SMALL-SIZE BEAM CONSIDERING SURFACE EFFECTS	2
OPTIMIZATION OF THE BEARING CAPACITY OF A STRINGER PANEL WITH A HOLE	2
SIMULATION OF VISCOELASTIC-PLASTIC BEHAVIOR OF SHALLOW SHELLS WITH ACCOUNT FOR STRAIN RATE OF MATERIALS	2
SPECIFIC FEATURES OF FORMATION OF SUPERSONIC JETS OF RAREFIED GASES UNDER CONDITIONS OF DEVELOPED CONDENSATION	2
NUMERICAL SIMULATION OF A FLOW IN A SENSOR FOR MEASURING THE FLOW STAGNATION TEMPERATURE IN IMPULSE WIND TUNNELS	2
Application of Wiedeburg Linearization for Solving the Stability Problem of a Two-Layer Mixture with Concentration-Dependent Diffusion	2
EVOLUTION OF BED FORMS PRODUCED BY CLARIFIED TURBULENT FLOW OVER A NON-COHESIVE BED	2
Effect of Cylindrical Turbulators on the Swept-Wing Boundary Layer: 1. Scenarios and Efficiency of Turbulization	2
ALGORITHM FOR 3D QUANTIFICATION OF ABDOMINAL AORTIC SHAGGINESS BASED ON LUMEN MORPHOLOGY ANALYSIS USING CTA IMAGES	2
SIMULATION OF DELAMINATION OF STEEL PIPES UNDER COMPLEX LOADING	2
ON THE ROLE OF THE HIDDEN INTEGRAL OF MOTION IN THE THEORY OF NON-SELF-SIMILAR SUBMERGED JETS OF A VISCOUS INCOMPRESSIBLE FLUID	2
ESTIMATION OF COUPLING IN A HEAT CONDUCTION EQUATION WITHIN THE DYNAMIC THEORY OF THERMAL ELASTICITY FOR A CLASS OF BRITTLE MATERIALS	2
APPROACH TO THE LABORATORY MODELING OF THE FLOW VELOCITY DISTRIBUTION BEHIND A HYDRO-TURBINE RUNNER. 1. DESIGN OF SWIRLER VANES	2
EFFECT OF THE TYPE OF A PLANE PROBLEM FOR A THIN ELASTOPLASTIC ADHESIVE LAYER ON $$J$$ INTEGRAL VALUES	2
Theory of Thermophoresis of a Large Evaporating Droplet in a Viscous Nonisothermal Binary Gaseous Medium	2