OOIR: Observatory of International Research

Papers

(The H4-Index of Materials Testing is 27. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-05-01 to 2026-05-01.)

Article	Citations
Influence of Borides on microstructure and mechanical properties of a Ni alloy	92
Mechanical behavior of carbon nanotubes reinforced polymer	83
Hardness and corrosion properties of AA7075 aluminum alloy coated with WC-Co by HVOF	75
Frontmatter	72
Retraction of: Numerical and experimental investigation of impact performances of cast and stretched polymethyl methacrylate panels	59
Microscopic characteristics of copper wires with short-circuit molten marks in electrical fire	58
Frontmatter	56
Frontmatter	54
Effect of Ti₃O₅ addition on oxide evolution for HRB400	52
Corrigendum to: Mechanical properties and wear-corrosion resistance of a new compound extrusion process for magnesium alloy AZ61	51
Bending moment calibration for rotational bending fatigue testing machine based on strain measurement	49
Operational wear behaviour of 3D-printed lightweight metal gears: EDS and oil analysis comparison	48
Investigation of tribological behavior of rice husk reinforced high density polyethylene (HDPE) biocomposite	46
Gas metal arc weldability of a Strenx 700MC-AISI304 dissimilar joint	45
Online monitoring of friction stir welding of dissimilar aluminum alloys	43
Effects of boride coating on wear behaviour of biomedical grade Ti–45Nb alloy	43
Effect of tool rotational speed on friction stir spot welds of AZ31B Mg alloy to AISI 304 stainless steel	37
Analysis of tool wear and surface roughness in machining of AISI 4462 duplex stainless steel	37
Effects of infill pattern and compression axis on the compressive strength of the 3D-printed cubic samples	36
Optimization of friction stir welding process parameters using multi-criteria decision making approach	35
Effect of heat-treatment on crash performance in bumper beam and crash box design and optimization of the system	33
Comparison of crash performance of auxetic structures for CF15, PA6/GF30, and GF30PP materials	32
Effect of temperature and rolling direction on the formability of CP2 and Ti-6Al-4V titanium materials	31
Minimization of release bearing load loss in a clutch system for high-speed rotations using the differential evolution algorithm	28
The effect of MWCNT concentration on the electrical resistance change characteristic of glass/fiber epoxy composites under low cycle fatigue loading	28

Effect of heat treatment on the properties of plasma arc welded TRIP800 steel	27
Tensile testing of S690QL1 HSS welded joint heterogeneous zones using small scale specimens and indentation methods	27