Materials Research Bulletin

Papers
(The H4-Index of Materials Research Bulletin is 47. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-08-01 to 2026-08-01.)
ArticleCitations
Editorial Board175
Optimization of blue upconverted light emission based on fluoroindate glass matrix and subsequent chitosan functionalization.117
Photocatalytic activity of Zn-Cu-S alloy for the removal of dye pollutant: Synthesis, characterization, optimization and DFT insights111
Interfacial modulation of SiC/TiC hybrid nanofibers for fabricating flexible ceramic electromagnetic wave absorbers103
Impurity level substitution of Cr and Ni in CaBaCo4O7 – a dielectric study99
A novel approach for the atomic scale characterization of Li-ion battery components probed by positron annihilation lifetime spectroscopy99
A facile synthetic strategy to MnS/NC submicrospheres for high-performance sodium-ion battery anodes93
Self-supporting NiCo carbonate hydroxyl nanosheet for ultra-high energy density and stable supercapacitors88
Corrigendum to “Empirical models for predicting cubic/pseudocubic lattice parameters of perovskites” [Materials Research Bulletin, 185(2025), 113318]86
Editorial Board85
Fine-tuning of composition in multi-layered core-shell rare earth nanoparticles for the enhanced NIR-II emission85
Synthesis, structural and dielectric properties of Ca3Mn2O7 thin films prepared by pulsed laser deposition84
NiCo bimetallic nanotrappers derived from recycled coffee grounds for capacitive energy storage81
Enhanced photogenerated carrier assisted ethanol oxidation via surface modification with perovskite to develop p-n type NiTiO3-NiO heterostructure80
Signal-On electrochemical aptasensor with a nanoengineered conductive interface for ultrasensitive detection of cancer-related biomarker78
Solar-photocatalytic treatment of industrial wastewater using mechanically doped CNS-TiO2 and synergistic TiO2 incorporation: A promising cost-effective approach for industrial wastewater treatment77
Modeling and measurement of dielectric anisotropy in materials manufactured via fused filament fabrication processes75
Multifunctional Eu3+ co-activated KNaCa2(PO4)2: Dy3+ phosphors: luminescent and colourimetric investigations for lighting and optical temperature sensing applications72
Low-temperature sintering and dielectric properties of (Ca,Sr)(Zr,Ti)O₃ with Li–B–Si glass in a reducing atmosphere: A candidate system for Cu-cofirable MLCCs71
Erbium substituted magnetite nanoparticles for hyperthermia applications: Synthesis, characterization, and performance evaluation69
Pyridine and carbon co-modified carbon nitride for synergistic photocatalytic hydrogen production and pollutant degradation67
Mixedmetal organic frameworks (Zn Mn-BTC) as a highly efficient material to improve pseudocapacitance performance of conductive polymer: Computational and electrochemical investigation66
Scalable nano-sized Fe-N-C catalysts for fuel cells: Evaluating the impact of iron precursors and CeO2 addition65
Effect of alkaline dopant Ba2+on TiO2 thin films: Insights of synthesis and properties64
Green synthesis of Carbon dot-Copper Oxide nanocomposite using Millingtonia Hortensis leaf extract: Characterization and antimicrobial studies63
Adjustable luminescence properties of Eu3+ and Bi3+ codoped Ca3Zn3Te2O12 phosphor63
Investigation on the dielectric and magnetic properties of perovskite-spinel (KNbO3-NiFe2O4) composites61
CVD–Grown CNTs on metallized fly ash cenospheres as tunable microwave–functional fillers60
Critical behavior and magnetic phase diagram of a topological kagome magnet ErMn6Sn660
Tailorable effective microwave absorption bandwidth of chitosan-derived carbon-based aerogel under different compression60
Recyclable Prussian blue/Clinoptilolite composite cascade activating persulfate for cleaning organics in water59
Oxygen vacancy association induced changes in photoluminescence of Eu3+ doped CeO2 codoped with Sc3+ and La3+58
Novel bimetallic magnetic nanocomposites obtained from waste-sourced bio-based substances as sustainable photocatalysts.57
Evaluation of the optical properties and radiation shielding effectiveness of Ho2O3-doped borate glasses56
High performance of asymmetric coin cells designed using optimized weight percentage of multiwalled carbon nanotubes in Ni/Co-MOFs nanocomposites56
Facile synthesis, characterization and acetone sensing properties of n-type WO3, SnO2 and VO2 semiconducting materials and their cobalt doped performance: Outstanding SnO2-Co acetone selectivity and s55
Structural functionalized TiO2-mediated photocatalysts as dye degradation agents: A systematic review53
Synergistic effect of polypyrrole modified WS2 nanosheets on visible light assisted catalysis for the removal of chromium (VI) and humic acid53
Sintering behaviors and microwave dielectric properties of Ba3P4O13 ceramics53
Evaluation of photocatalytic properties of zinc and cobalt mixed oxide recycled from spent Li-ion and Zn–MnO2 batteries in photo-Fenton-like process51
Effect of sintering mechanism on dielectric properties of Ba0.5Sr0.5TiO3-ZnAl2O4 composite ceramics synthesized by two-step sintering with low energy consumption50
Synthesis and optical properties of blue inorganic pigments with tetrahedrally coordinated Co2+/Ni2+ in Li2ZnSiO450
Synthesis of magnetically recyclable g-C3N4/NiFe2O4 S-scheme heterojunction photocatalyst with promoted visible-light-response photo-Fenton degradation of tetracycline49
Constructing F-TiO2/Bi2S3 nanoflower heterojunction to improve charge separation for efficient organic pollutant degradation49
Synthesis of superparamagnetic Fe3O4-PEG400 nanoparticles: Investigation of interaction with proteins and toxicity on cells48
Enhanced electrocatalytic hydrodechlorination of 2,4-dichlorophenol over palladium nanoparticles loading on dendrite-like Ni-Cu-P interlayer48
Enhancing the efficiency and stability of Cs2AgBiBr6 solar cells via MAPbBr3 decoration48
A novel rGO-ZnFe2O4 hollow microsphere composite with excellent microwave absorption properties47
Multiscale structural characterization and regulatory mechanisms of fly ash for mullite ceramic applications47
Facile preparation of nickel-poor layered double hydroxides from mechanochemically pretreated gibbsite with a variety of interlamellar anions and their use as catalyst precursors for CO2 hydrogenation47
Sol Gel obtained Ti/Co/Mn oxides doped with 5wt% CuO for the photocatalytic removal of organic azo dyes from wastewater47
Zeolitic imidazolate framework (ZIF) derived MoS2/Co3S4/NPC as the supercapacitor electrode material47
0.26301407814026