Oxidation of Metals

Papers
(The median citation count of Oxidation of Metals is 4. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-11-01 to 2025-11-01.)
ArticleCitations
Impact of Alkalis and Chlorides from Sugarcane Agriculture Residues on High Temperature Corrosion: A Review37
Ni–Co/ZrO2 Composite Coatings via Electroless Plating on Crofer 22APU for SOFC Interconnect Applications: Oxidation and Chromium Vaporization Behavior18
High-Temperature Oxidation Behavior of a Silico-Aluminized MCrAlY Coating on a Ni-Based Superalloy10
The Effect of Niobium and Carbon on the Oxidation Resistance of Alloys Based on Fe3Al at 900°C9
Influence of Yttrium Doping on the Oxidation of Mo(Si,Al)2 in Air at 1500 °C9
Formation of Thermally Grown Aluminum Oxide Scale on the Surface of Ni2Al3/Ni Layered Coating9
Mechanical Stress Effects on 550 °C Hot Corrosion Propagation Rates in Precipitation Hardened Ni-Base Superalloys: CMSX-4, CM247LC DS and IN6203DS9
Invited Review Paper in Commemoration of Over 50 Years of Oxidation of Metals: Alumina Scale Adhesion Mechanisms: A Retrospective Assessment9
The Effect of Tungsten Addition to Fe-9Cr Alloy on Steam Oxidation Behavior at 923 K9
Solid-State Deposit-Induced Corrosion of a Second-Generation Nickel-Based Superalloy Caused by CaO and CaSO4 Deposits9
Improving Selectivity on High-Temperature Decarburization Depth Measurements using an Image Segmentation Method9
Hot Corrosion Behavior of a Powder Metallurgy Superalloy Under Gas Containing Chloride Salts8
Effect of Temperature Gradient in Ash on High-Temperature Corrosion of Super-Heater Material in a Waste Power Generation Boiler7
The Effect of APS-HVOF Bond Coating Thickness Ratio on TBC Furnace Cycle Lifetime7
Predicting Oxidation Behavior of Multi-Principal Element Alloys by Machine Learning Methods7
Role of Si in the Oxide Nucleation and Growth Mechanisms of 60Si2Mn Spring Steel: Experimental and First-Principles Study7
Stochastic Model for High Temperature Oxidation of Cr–Ni Austenitic Steels Assisted by Spallation6
High-Temperature Oxidation Behaviour of a TiAl-Based Alloy Subjected to Aluminium Hot-Dipping6
Protective Alumina Scale Growth at 900 °C for a Ni- and Cr-Free Co-Base Model Alloy with γ/γ’-Microstructure: Synergistic Effects by Combining Shot-Peening and Halogenation6
Internal Oxidation of a Fe–Cr Binary Alloy at 700–900 °C: The Role of Hydrogen and Water Vapor5
Oxidation Lifetime Modeling of 625 and 120 Foils After Long-term Exposure in Flowing Air + 10%  $${\hbox {H}_2\hbox {O}}$$ at 700 and 800 $$^\circ$$C5
Impact of Sample Geometry and Surface Finish on VM12-SHC Ferritic–Martensitic Steel Under Cyclic Steam Atmosphere Operating Conditions5
Effect of Hydrogen on the Internal Oxidation of a Pd–Cr Alloy in Dual-Atmosphere Conditions5
In Situ Oxidation in Ni-Based Single-Crystal Superalloys with Varying Re Contents Observed by Environmental Transmission Electron Microscopy4
A Mathematical Model for the Prediction of the Scale Layer Formation on ASTM A510/A853 Cold-Drawn Hypoeutectoid Steel Wire After Batch Annealing4
Effect of Nanocrystalline Structure on the Oxidation Behavior of Fe–20Cr–3Al Alloy at High Temperatures4
The Oxidation of Four Co-20Ni-xCr-yAl (x = 8,15 wt.%; y = 3,5 wt.%) Alloys Under 1 atm O2 at 800 °C and 900 °C4
Formation of Si Diffusion Layer on Fe and Fe–Cr Alloy and High-Temperature Corrosion Resistance in a Molten Salt4
0.043554067611694