OOIR: Observatory of International Research

Papers

(The H4-Index of Materials Chemistry and Physics is 54. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-06-01 to 2025-06-01.)

Article	Citations
In situ synthesis and characterization of TiB2/FeMnAl metal matrix neutron absorption composites	135
Surface modification of cotton fabric by kaolin-derived zeolite N to enhance efficient removal of particulate matter	123
Thermomyces lanuginosus: A prospective thermophilic fungus for green synthesis and stabilization of BioAgNPs through glucoamylase	119
Structure, ferroelectric and magnetic behavior in Mn doped 0.75 BiFeO3-0.25BaTiO3 ceramics	104
Elimination of NO3 - from water using Pd and PdCu catalysis supported on ZrO2–CeO2 materials: Effect of the support preparation	101
Bilayer molybdenum contact prepared via high-power pulsed magnetron sputtering: Effects of substrate bias	96
Thermoset poly(2-methoxyethyl acrylate)-based polyurethane synthesized by RAFT polymerization and polyaddition	93
Quaternary ammonium ionene porous polymers via Menschutkin reaction of methylated polyethyleneimine and dibromoalkanes	86
Assessing the structural and interaction behaviour of Pr@Gd2O3 nanoparticles with biological entities	85
Chemo-mechanical processing of hot chamber die cast scrap to design ZnO-based composite anode for lithium-ion batteries	84
Enhanced charge transfer and photocatalytic performance of cube-shaped Ag3PO4@Zeolite-A nanocomposite	82
Highly enhanced luminescence of Gd2O3:Ho3+ phosphor by heat treatment	82
Simultaneously improved surface hardness and thermal diffusivity of carbon nanotube/zinc silicate composites via colloidal processing	81
Improved Difenoconazole pesticide detection limit via double-sided porous silicon layers' electrical sensor	81
Fabrication of cold sintered soft magnetic composites using oxalate coated iron powders	76
Silica extracts from fly ash modified via sol-gel methods and functionalized with CMPO for potential scavenging of rare earth elements La³⁺ and Ce³⁺	76
Influence of graphene oxide and carbon nanotubes on physicochemical properties of bone cements	75
Highly precisive arrangement of continuous carbon fiber and its reinforcing effect on hydroxyapatite	74
Doping-induced Ti3+ state and oxygen vacancies in TiO2: A single-chip combinatorial investigation	72
Post-deposition annealing effect on the structural and electrical properties of ytterbium oxide as an alternative gate dielectric	71
Temperature-controlled synthesis of novel boron nanofibers by laser ablation technique	69
Ultrasound-assisted adsorption of dyes and cadmium ion from aqueous solutions by ZnAl2O4 nanoparticles	68
Corrigendum to “Surface modified porous silica-alumina glasses with enhanced hydrothermal stability for biomass conversion” [Mater. Chem. Phys. 289 (2022) 126504]	67
Revealing the effect of Gd alloying on oxidation resistance and oxide film protection performance of AZ80 alloy	66
The differential influence of biochar and graphite precursors on the structural, optical, and electrochemical properties of graphene oxide	66

Effect of hydrogen evolution on morphology and capillary performance of electrodeposited copper wicks	63
Microwave electrodeposited Ni on Cf for synergistic improvement of compressive and thermoelectric properties of cement-based composites	63
Microstructural influence on corrosion behavior and the TiO2 nanostructured layer growth in the Ti–10Mo–3Sn alloy	63
Radioactive iodine capture by hexagonal boron nitride (h-BN) nanosheets in liquid and vapor phases: Experimental and theoretical studies	62
Exploring the utilitarian aspects of a noxious exotic weed, Lantana camara: From green synthesized nanoparticles to a new frontier in biomedical innovation	62
Thermal stability and crystallisation behavior of newly developed Cu–Zr–Ag–Ti–Ni multicomponent bulk metallic glass	62
Evaluation of multifunctional marine coatings enriched with organometallic biocides supported on ZSM-5 zeolite for biofouling prevention	62
Facile modification method for the controlled synthesis of dumbbell-like gold nanoparticles (AuNDBs) for application in detecting glucose using the SERS method	61
Photocatalytic reduction of CO2 over K2Ti6O13 films	61
Strain rate sensitivity behaviour of Fe–21Cr-1.5Ni–5Mn alloy and its constitutive modelling	60
Mechanical activation of anatase as a way to improve hexavalent chromium removal from solutions by the photoreduction and adsorption under near visible LED irradiation	60
A comparative study of the structural, vibrational, electronic and thermoelastic properties of α−SiO2 and α−Si(NH)2 from first principles	59
Structural, thermodynamic, electronic, and magnetic properties of superconducting FeSe–CsCl type: Ab initio searching technique with van der Waals corrections	59
The surface degradation and its impact on the magnetic properties of bulk VI3	59
Surface plasmon resonance effect on charge transfer in Ag@Cu2O-rGO composites	59
Characterization and electrochemical properties of Pt nanoparticles deposited on titanium oxide nanofibers	57
Designing a more efficient CsSnI3 based perovskite solar cell with novel bio-synthesized ZnO-NP as ETL	57
Mineralized nodule formation in primary osteoblasts culture in titanium doped phosphate glass and in-house prepared freeze dried demineralized bone extracts	57
An ultrasonic study of the effect of uniaxial green compaction pressure on the elastic anisotropy of porous copper fabricated using the pore-former route	57
Enhanced ethanol sensing response of nanostructured Ce-doped CuO thin films	57
Hetero-valent cations-doped zinc stannate nanoparticles for optoelectronic and dielectric applications	57
A perspective of recent advances in PECVD-grown graphene thin films for scientific research and technological applications	56
Improved oxidation stability of carbon-coated Ni nanoparticles synthesized by one-step electrical wire explosion	56
Investigation of tensile and fatigue properties of an austenitic stainless steel part fabricated by WAAM	56
A nanostructure of reduced graphene oxide and NiO/ZnO hollow spheres toward attenuation of electromagnetic waves	56
Thermoluminescence investigations of Ca2Al2SiO7: Dy3+ phosphor for gamma dosimetry applications	56
Investigating long term storage stability and drug release behavior of polypeptide based fibrous scaffold for tissue engineering application	55
Ionic liquid composites with garnet-type Li6.75Al0.25La3Zr2O12: Stability, electrical transport, and potential for energy storage applications	55
Template free zinc vanadate flower synthesis, characterization and efficiency for cetirizine-dihydrochloride degradation under UV light irradiation	55
Synthesis of Zr–Fe2O3/In2O3 photocatalyst by novel hydrothermal method for highly selective photo inhibition of pathogens, pollutant degradation and DPPH stabilization	54
Study on denitration performance of mineral catalyst prepared by high energy ball milling of rare earth concentrate supported Fe2O3 for NH3-SCR	54
Magnetic properties of nano(iron oxide)-decorated graphene oxide	54
ZnO nanoflowers modified pencil graphite electrode for voltammetric DNA detection and investigation of Gemcitabine–DNA interaction	54