Noise Control Engineering Journal

Papers
(The median citation count of Noise Control Engineering Journal is 0. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-05-01 to 2026-05-01.)
ArticleCitations
Acoustic source reconstruction of a commercial generator set using inverse pellicular modes and inverse numerical panel contribution analysis15
A speech jammer using ultrasonics for speech privacy protection and smart speaker attack prevention15
Conditions for sound absorption caused by longitudinal vibration of lightweight powder10
A Weighted Exponential Bilinear Functional Link Artificial Neural Network Filter And Weighted Filtered-s LMS algorithm For Saturation Nonlinearity6
Research on fast optimal reference sensor placement in active road noise control4
Input force and floor impedance measurement for the standard tapping machine and the standard impact ball3
Survey of aircraft noise abatement strategies in the US3
Frequency reduction and attenuation of the tire air cavity mode due to a porous lining3
Case study: Noise attenuating performance of perforated corrugated lined straight-through perforated pipe-resistant muffler3
Adaptive ANC algorithm for internal and external dual-channel noise3
Influence of the vibrating source behavior and source side excitations on the Interface Completeness Criterion3
A method of generating car sounds based on granular synthesis algorithm3
Research on pipeline state recognition method based on acoustic signal frame PCA3
An experimental modal decomposition method to compute sound power of multi-dimensional acoustic waves from turbocharger compressors2
A nonlinear noise active control algorithm based on deep neural network2
Design and validation of micro-vibration isolator for reaction wheels in consideration of launch environment of satellite2
Estimation of transfer matrix by applying the theoretical acoustic incident impedance of a lightweight powder layer to the two-thickness method2
Optimal duct length of ducted fans for minimizing first blade-passing frequency noise2
Theoretical and experimental investigations for noise reduction of clearance joints in vertical vibrations2
Case study: Analysis of acoustic-structure coupling noise characteristics of the exhaust muffler of an internal combustion engine2
Nomogram-Based Approach for Noise Level Prediction of Pneumatic Rock Drill2
Experimental study of sharp noise caused by rotating detonation waves2
Estimating effective acoustic properties of various configuration of perforated panels2
Assessment of aerodynamic noise sources around an automobile-door mirror using a hot-film sensor2
Informing Consumer Product Sound Quality Analysis using Generative Adversarial Networks2
Experimental study on the influence of hole parameters on vibration response of spur gear pair with damping particles2
Boosted Fourier nonlinear filter and boosted even mirror Fourier nonlinear filter for active control of machinery noises2
Warmstarting strategies for convex optimization based multi-channel constrained active noise control filter design2
Improvements to methods to create realistic simulations of non-stationary vehicle wind noise for use in psychoacoustic tests2
Test method for evaluating the NIOSH Noise Mapper application in a hemi-anechoic chamber2
Numerical study on the optimization of two-dimensional valve structures based on LES for cavitation noise suppression2
Evaluation of Tire-Road Noise Sound Quality on Dense-graded Asphalt Concrete Pavements Using Physical and Psychoacoustic Parameters2
Case Study: Assessing blast-induced air overpressure in tunnel excavation: a finite element analysis based approach2
The propagation characteristics of flexural wave in periodic ballast track2
Case study: Simulating and measuring the vibration and radiated sound of a large industrial chiller1
Listening tests results of vehicle pass-by auralization1
Improvement of micro-perforated panel absorbers sound performance using resistive screens and sensitivity analysis of the composite absorber models1
New experimental and theoretical methods to model perforated plate in the presence of grazing airflow1
S-method based on modified group delay for time-frequency analysis1
Design and Acoustic Properties of Novel Embedded Honeycomb Structures1
Experimental contribution analysis of external noise components to interior noise of an automobileExperimental contribution analysis of external noise components to interior noise of an automobile1
Enhancing ventilation holes acoustic performance through perforated absorption plate1
A hybrid method for creating auralizations of vibroacoustic systems1
Case study: Hybrid inverse method for aircraft noise abatement isolator: Experimental and vibroacoustic assessment1
Case study: Reference optimization for active control of air conditioning noise at defrost mode in vehicles1
Electromechanical Modelling and Analysis of Motor Whine in Electric Propulsion Systems1
On the effect of the grille on the acoustic frequency response of a tweeter loudspeaker1
Detection and identification of solid emboli and gas emboli in simulated blood using ultrasonic doppler1
Pass-by noise prediction of motor vehicles using gradient boosted models and physical calculations of longitudinal driving dynamics1
Investigation on acoustic performance of distributed periodic micro perforated panel1
Experimental dynamic flow characterization of hydraulic bushings1
Estimation and experiment of acoustic properties of rice straw (estimation of sound absorption coefficient using CT images)1
The use of artificial neural networks to predict tonal sound annoyance based on noise metrics and psychoacoustics parameters1
A method of sound source recognition based on two stagewise weak orthogonal matching pursuit1
Acoustic measurement of super-small-particle-filtering stainless steel wire cloths1
Feature Analysis for Fault Diagnosis in Electrified Powertrains1
Uncertainty of in situ low frequency reverberation time measurements from 20 Hz – An empirical study; Part II: Impulse response method1
Meshing characteristics and dynamic characteristics of planetary transmission system with new tooth-type flexible ring gear1
Toward high-quality X-59 sonic thump measurements1
Head movement effects on the performance of an ANC headrest in a car cabin1
Bioinspired acoustic metamaterials: mimicking the cuttlebone for advanced noise control applications1
Unmanned Aircraft/Aerial System (UAS) Noise Compilation1
Adaptive ANC algorithm for internal and external dual-channel noise0
Input force and floor impedance measurement for the standard tapping machine and the standard impact ball0
Occupational Noise Exposure of Farm Operators: Hazards and Controls0
Case study: Knowledge, attitude, and practice (KAP) regarding hearing protection: A case study among offset printing industry workers in Tehran province0
Study on noise reduction method of main noise transmission path of axial piston pump with new damping material0
Sound Exposure Level corrections for flight altitudes of small aerial vehicles0
Analysis of the effect of combined noise reduction measures of trapezoidal sleeper and sound barrier on elevated line0
Modeling and optimizing a broadband sound absorber consisting of a granular activated carbon stack backed by a poro-elastic layer0
Case study: A type of low-noise power capacitor based on combined microperforated panels0
Experimental study on the influence of hole parameters on vibration response of spur gear pair with damping particles0
Comparison and analysis of vibration characteristics of different subway tracks0
Research and modeling of the bistatic acoustic scattering characteristics of novel multi-faceted conning tower0
An improved parallel narrowband active noise control system with local on-line secondary-path modeling equipped with frequency estimation algorithm0
Developments on ground blocking implementation in turbulence tool for sonic boom propagation0
On optimum speaker placement with a model-based approach for indoor local active noise control applications0
Evaluating bridge-borne noise contribution degree for a railway steel–concrete composite box girder0
Prediction of broadband noise generated from low-pressure fan based on experimental pressure power spectral density0
Duplex wireless communication integrated multi-channel active noise control system for ICU patient’s bed0
Positioning error estimation of honking detection systems based on YOLOX0
Case study: World Health Organization's guidelines for environmental noise revisited0
Study on the acoustic performance of a coupled muffler for diesel engine0
Variability of small multirotor aircraft noise measurements0
Perception of non-stationary wind noise in vehicles0
Development of aircraft noise simulation framework J-FRAIN based on component-wise sound source models0
Case study: Acoustic radiation characteristics and mechanism of high-speed railway box-girder bridge0
Active noise cancellation using hybrid CNN-LSTM classification and genetic algorithm-based community detection extraction with LMS noise filtering process0
Construction of interpolated source from dynamic flights (UAV/AAM Special Issue)0
Improvement of a soundproofing vent hole0
Engineering considerations for the development of disk spring stacks for vibration isolation0
A new speech enhancement method based on Swin-UNet model0
Structural vibration reduction achieved by lightweight porous layers through the near-field damping effect: A technical summary0
Application of multivariate adaptive regression splines technique for blast-induced air overpressure control in mines using large dataset0
Case Study: Research on a Wireless Monitoring System for Vibration-Damping Track Structures of Chongqing Metro Oriented to Intelligent Operation and Maintenance0
Case Study: Assessing blast-induced air overpressure in tunnel excavation: a finite element analysis based approach0
Health burden of road traffic noise in the EU in 2020–20350
A method to simulate printer noise for use in psychoacoustic tests0
Research on the engineering calculation method of acoustic radiation of open-frame multi-cabin structure0
Enhancement of speech through source separation for conferencing systems0
Case study: Disc-brake squeal noise reduction through material selection and robust shape optimization0
Source characterization of a ducted source using acoustic free velocity0
Deep learning-based mechanical fault detection and diagnosis of electric motors using directional characteristics of acoustic signals0
State of the art of rational design of efficient mufflers0
Finite element analysis of sound absorbing material with periodic decreasing hole profiles0
Advances in elastomeric mount concepts for quasi-zero stiffness isolation0
A single-step measurement method for transmission loss of the muffler based on improved transfer matrix0
Noise distribution law of air-conditioning ducts for metro vehicles0
Wave propagation analysis for three typical box girders: Dominant wave modes and their applications0
Case study: Noise risk assessment of workers at the mechanized mining face of coal mines0
Case study: Design and properties of acoustic energy harvester0
Analysis and control of vehicle steering wheel vibration based on acceleration transfer path analysis method0
Experimental investigation of cavitation-induced noise and vibration in a centrifugal pump0
Experimental study on sound absorption performance of microporous aluminum square tube space absorber0
Case study: Sensitivity analysis of transmission loss through treated composite panel: An experimental and numerical study0
Active Noise Control in Open Spaces Using Directional Parametric Loudspeakers0
An improved estimation method of secondary path uncertainties for feedback active noise control earphones0
Model-Based Current Filter Design for Control of Vibrations due to Electric Motor Faults0
Case study: OtologMap: a case study on the construction of an environmental sound map recorded by smart devices at Okayama and Kurashiki0
Development of direct acoustic energy flow analysis (DAEFA) for ship cabin noise in the medium-to-high frequency range0
Case study: Analysis and research on pipeline vibration of liquid oxygen kerosene of rocket engine and vibration reduction measures Measures0
Case study: Empirical study on indoor environmental sound classification to support hearing-impaired persons0
Effect of geometrical defects on the acoustical transport properties of periodic porous absorbers manufactured using stereolithography0
A fast sound power prediction tool for genset noise using machine learning.0
Assessment of environmental noise scenario and correlation of Air Quality Index and sound levels of urban zones of Delhi City, India0
Development of an empirical model for the prediction of the noise reduction coefficient for thin and low-density fibrous materials0
An improved evaluation method of industrial noise based on level of noise pollution and kurtosis-weighted cumulative noise exposure0
Finite element modeling of acoustic metamaterial based on periodic Helmholtz resonator with a membrane in the cavity0
Nonwoven fabric sheet with back air space serving as Helmholtz resonator0
The effects of Helmholtz resonator wall elasticity on the sound attenuation performance0
Case Study: SSEGAN: Incorporating Channel Attention Mechanism into SEGAN0
A constrained multi-channel hear-through filter design approach using active control formulations0
Acoustic performance of cavities with gradient changes of cavity numbers under low lattice constant in a soft elastic medium0
A novel method for fast calculation of the noise emission from an axial piston pump0
Evaluation of machine learning performance on source separated passive acoustic recordings0
Investigating noise radiation pattern of railway bridges for urban rail transit0
Examination of Candidate Calibration Samples for Normal Incidence Impedance Measurements0
Analysis and Design of Active Sound Absorption Muffler Based on Acoustic Electric Analogy0
Metro noise-induced activity disturbances and their water sound-based countermeasures0
Design and analysis of periodic acoustic metamaterial sound insulator using finite element method0
Tunable sound packages consisting of granular aerogels and fibrous media0
Acoustic absorption properties of a composite structure of stepped micro-perforated plates with double-layer foam metal0
Band gaps in an acoustic metamaterial composed of resonator with elastic support0
Research on Flow Noise of Water Pipeline Based on Bionic Regulation0
Case study: Effect of asymmetry of vibration on the perceived illusion force0
Case study: Research on the soundscape of Taoist temples in Northeast China0
A hybrid simulation approach to predicting noise in restaurants0
Effect of porosity, pore size, and pore-opening size optimized on the sound absorption coefficient of aluminum foam0
Impacts of growing time and physical modifications on the acoustical properties of mycelium-composite materials0
Free and forced vibration analysis of a Z-shaped structure with multi-span elastic supports0
Theoretical estimation of sound absorption characteristics in a collection of rectangular holes: Comparison with experimental results0
Difference in the perceived loudness of sound between Chinese men and women0
Research on the design of hear-through controllers for active noise control headphones based on cascade biquad filters considering different directions of sound arrivals0
A novel feedforward narrow-broadband hybrid active noise control system for excavator interior noise control0
Sound power estimation method based on dual arrays sound intensity scaling and sound pressure superposition0
Case study: Analysis of the effect of sound-absorbing materials on sound absorbing properties of foamed aluminum and a study on noise reduction0
Research on seat active noise control of driver's cab ground platform based on far-point secondary sound sources0
Vector based acoustic sensing for mechanical fault classification through convolutional neural networks0
Mathematical modeling and experiments on the acoustic properties of a frame structure with a membrane0
Case study: Sub-metamaterials for Broadband Aircraft Noise Reduction Across Low and High Frequencies0
Time-series prediction and forecasting of ambient noise levels using deep learning and machine learning techniques0
Radiation resistance matrix for baffled simply curved plates for sound power applications0
0.054934978485107