ISIJ International

Papers
(The H4-Index of ISIJ International is 19. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)
ArticleCitations
Characterization of Formation of Ferrous and Ferric Oxides in Aqueous Solution from a Multidisciplinary Viewpoint32
Isothermal Structure Transformation and Kinetics Behavior of Oxide Scale on Low Carbon Steel31
Evaluation of Effective Diffusion Coefficient under Time-Varying Electromagnetic Force Imposition29
Detection and Characterization of Organic Gases during Coal Carbonization Using VUV-SPI-TOFMS26
Formation Mechanism of Secondary Inclusions in Fe-36mass%Ni Alloy Using a Novel Combination Analysis Technique26
Apparent Viscosity Measurement of Gas–liquid Multiphase Fluids by the Falling Ball Method24
Initial Oxidation of Fe–Cr Alloys at Different Temperatures and Atmospheric Conditions: A ReaxFF Molecular Dynamics Approach24
<i>In-situ</i> Observation of Sliding Interface in Commercially Pure Titanium Sheet with a TiO<sub>2</sub> Film24
Burden Particle Contour Extraction from Digital Elevation Model of Blast Furnace Rough Surface22
Proposal of New Decision Method for Temperature Control Time in Fracture Toughness Test22
Local Structure Investigation of Cu Precipitates in Modified 18CrNiMo7-6 Steels by Synchrotron X-ray Absorption Spectroscopy21
Slag Formation Behaviour at Interface between Pre-reduced Lump Iron Ore and CaO under Load Conditions21
Interaction Coefficients of Mo, B, Ni, Ti and Nb with Sn in Molten Fe–18mass%Cr Alloy21
Creep Rupture Strength and Phase Stability of the Austenite Phase for KA-SUS304J1HTB21
Nitride Precipitation during Isothermal Heating after Rapidly Cooled from High Temperature in Duplex Stainless Steel20
Estimation of True Hardness and Quantitative Evaluation of Auto-Tempering in As-Quenched Martensitic Steels20
Effect of Grain-boundary Phases on the Tensile and Compressive Creep Behavior of a Ni–Co Based Superalloy with High W Content19
Microstructure Characterization of Al–Si Coatings on Hot Stamping Steel under Different Heat Treatment Processes19
Energy and Environmental Savings by and for Steel Lightweight19
Wettability of Molten Fe–Al Alloys against Oxide Substrates with Various SiO<sub>2</sub> Activity19
0.08127498626709