Journal of Alloys and Compounds

Papers
(The H4-Index of Journal of Alloys and Compounds is 88. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)
ArticleCitations
Upper critical field and peak effect in (Li0.8Fe0.2)OHFeSe single crystal296
Magnetic regulation in the off-stoichiometric L10-MnGa thin film by Fe doping276
Magnetic phase diagram of helimagnetic Ba(Fe1−Sc )12O19 (0 ≤ x ≤ 0.2) hexagonal ferrite218
Influence of Zn2+ and Sb5+ co-substitution for Sn4+ on crystal structure and electrical conductivity of SnP2O7 electrolyte217
Comments on the paper “Fabrication and physical characteristics of K/W double doped BiFeO3 complex electro-ceramic; (Bi1/2K1/2)(Fe1/2W1/2)O3”213
Editorial Board211
Preparation of SiO @TiO2@N-doped carbon composite using chitin as carbon precursor for high-performance lithium storage211
The electrochemical characterization and kinetic investigation of sub-micron Bi2Fe4O9 as possible anode of advanced lithium-ion batteries207
Positive stretching dependence of resonance frequency in CoFeB films modulated by lateral growth pre-strain183
The effect of sodium formate mediated double regulation in TiO2 photocatalytic reduction of cadmium180
Development and precise determination of high reproducibility Ga-In eutectic temperature fixed point179
Crystallization kinetics and microstructural analysis of lanthanum-modified zinc alloys175
Temperature-induced phase transition of PNZST ceramics near the morphotropic phase boundary for thermal-electrical energy conversion175
Effects of solid isolation medium on the microstructure and magnetic properties of one-step sintered L10-FePtCu nanoparticles173
Corrigendum to “A novel direct Z-scheme heterojunction BiFeO3/ZnFe2O4 photocatalyst for enhanced photocatalyst degradation activity under visible light irradiation” [J. Alloys Compd. 912 (2022) 165185171
WITHDRAWN: Novel design of Sn4P3@NxC electrodes and their electrochemical properties171
Corrigendum to: “In situ absorption synchrotron measurements, predictive modeling, microstructural analysis, and scanning probe measurements of laser melted Ti-6Al-4V single tracks for additive manufa169
Superdispersed NiCo2S4 nanoparticles anchored on reduced graphene oxide for efficient hydrogen evolution reaction in acidic and alkaline media168
Dipole–Quadrupole interactions between Sm3+ ions in KY3F10 nanocrystals166
Effects of hydrogen pretreatment on the nitridation, microstructure, and magnetic properties of Sm2Fe17N3162
Research on biaxial tensile deformation behavior of CP-Ti by experiments and crystal plasticity simulations155
Converse magnetoelectric effect in three-layered composites based on amorphous ferromagnetic Fe0.45Co0.45Zr0.1 alloy and relaxor (1 - x)PbMg1/3Nb2/3O3 - xPbZr0.53Ti0.47O3 ceramics155
Role of boron addition in tuning microstructure and mechanical properties of AlNbTiZr based multiprincipal element alloy144
Unveiling the supercapacitive potential of MWCNT/Zn0.76Co0.24S/Co4S3 microcauliflowers as an advanced electrode material for sustainable energy storage applications141
Photo-dielectric response enhancement and switching behavior of (1-x)(K0.5Na0.5)NbO3-xCa(Ni0.5Nb0.5)O3-δ ceramics by semiconduction method139
Construction of h-BN/Cu2O/FeCoNi nanocomposite in double-layer configuration unveiling superior optical, x-band absorption and mechanical performance138
Layered quaternary chalcogenides KMgCuSe2 and KMgCuTe2 with paramagnetic semiconducting behavior137
Microstructure evolution and accelerated magnetocaloric phase formation of LaFe13.1Co0.7Si1.4 alloy by forging deformation at room temperature136
Tailoring degradation of MgZn alloy films with bioinert amorphous carbon135
Optimizing microstructure and mechanical properties of bimodal-structured magnesium matrix composites by regulating the remelting time of powder thixoforming134
Flower-like SnO2 nanorod aggregates modified with Co3O4 nanoparticles grown on reduced graphene oxide(rGO) sheets for xylene sensing132
Improvement in microstructure uniformity and mechanical properties of surface modified graphene reinforced Ni-based composites by laser deposition132
Microstructure inducement of different tensile fracture mechanisms at 800 ℃ of directional solidified Ti-45Al-5Nb alloys produced by electromagnetic confinement129
Influence of oxidant and sample state on oxides distribution of Ag-4.93Sn-3.56In alloy powders123
High non-linear electrical properties of Li3xCo7–4xSb2+xO12 a new ceramic varistor122
High-resolution topochemical analysis and thermochemical simulations of oxides and nitrides at grain boundaries and within the grains of a low alloy Mn-Cr hot-rolled steel sheet120
Improved Co-substituted zinc vanadate ceramics based on LTCC for enhanced polarization converters120
Au tailored on g-C3N4/TiO2 heterostructure for enhanced photocatalytic performance120
Improved threshold switching characteristics of vanadium oxide/oxynitride-based multilayer selector in a cross-point array117
Unexpected atmosphere effect on the iron oxide growth by the Laser Floating Zone method116
Enhanced thermoelectric performance of n-type Bi2Te2.7Se0.3 by pyrite CoSe2 addition115
Structural transformation and transport behavior of mixed valence compound Sn3O4 under high pressure114
Neo-heterojunction based on the kesterite copper chalcogenide semiconductor with magnetic iron-cation partial-substitution: In-situ room-temperature pulsed laser deposition and optoelectronic properti113
A new D-A-D type benzodithiazole-based hole transport material for Sn-Pb perovskite solar cells with high efficiency and stability112
Conducting surface layers formed by hydrogenation of O-implanted β-Ga2O3112
Cooperative non-covalent interactions-directed the supramolecular self-assembly and its derivative for bifunctional water electrocatalysis111
Microstructure and corrosion resistance of ultrahigh pressure Mg-8Li based alloys110
Synthesis of sub-micron LiNi0.5Mn1.5O4 with uniform size distribution by oleylamine-assisted solid-state method109
The spin reorientation and improvement of magnetocaloric effect in HoCr1-Ga O3 (0 ≤ x ≤ 0.5)109
Experimental investigation and thermodynamic calculation of the Co-Al-Mo ternary system109
The effects of tensile stress on the microstructure evolution and elemental interdiffusion behavior of (Ni,Pt)Al coating and nickel-based superalloy at 1100 ℃ for 200 h108
A novel SnS2 nanomaterial based on nitrogen-doped cubic-like carbon skeleton with excellent lithium storage106
Crystal structure of the τ11 Al4Fe1.7Si phase from neutron diffraction and ab initio calculations106
Correlation of crystal orientation, crystal morphology and mechanical properties of directionally solidified Mg-xGd alloys105
Effects of A/B ratio on the dielectric properties and AC conductivity behaviors of La-doped SrTiO3 with colossal permittivity105
Li10Sn0.95P2S11.9−xOx: A new sulfide solid electrolyte for all-solid-state batteries103
Electrochemical characteristics of Sr-deficient SrTi0.3Fe0.7O3−δ oxygen electrodes for solid oxide electrolyzers102
Polarity-dependent fatigue behavior of domain switching kinetics in textured ferroelectric Al0.72Sc0.28N thin films101
Effect of metallic contacts diffusion on Au/GaAs and Au/GaN/GaAs SBDs electrical quality during their fabrication process101
Novel preparation of MOF derived Co(OH)2/ZnFe2O4 magnetic micro-nanoreactor with boost peroxymonosulfate activation for enhanced antibiotic contaminant oxidation100
Field-induced tricritical phenomenon of the van der Waals magnetic material CrVI6100
Optimized crystallization and defect passivation with Yttrium (III) doped MAPbBr3 film for highly efficient and stable hole-transport-layer-free carbon-based perovskite solar cells100
Room-temperature self-calibrating sensor based on CsPbBr3/SnO2 for detecting low-concentration sulfur dioxide99
Oxygen concentration – A governing parameter for microstructural tailoring of duplex AlCrSiON coatings for superior mechanical, tribological, and anti-corrosion performance98
Synergistic regulation of sulfur-group elements doping and strain on the thermoelectric performance of innovative material Er2Te398
X-ray peak broadening analysis of Bougainvillea glabra assisted ultrasonic exfoliation of h-BN sheets98
Designing dual-functional mesoporous g-C3N4 nanosheets doped with KPF6 for H2O2 production and antibiotic degradation98
Microwave-assisted preparation of PtCu/C nanoalloys and their catalytic properties for oxygen reduction reaction96
Chemistry evolution of LiFePO4-NaHSO4·H2O system during roasting and recovery of Li and Fe96
Understanding of the enhanced coercivity and energy product in Sm(CobalFe0.27Cu0.05Zr0.02)z permanent magnets with lower z value96
Magnetic/optical assessments of RFeO3 (R=La, Pr, Nd, and Sm) ceramics: An experimental and theoretical discernment95
Oxygen vacancies boosted photoelectrochemical performance of α-Fe2O3 photoanode via butane flame annealing95
Ultrafine lamellar-structured FeCrAl alloys with enhanced mechanical properties manipulated by Al1.8CrCuFeNi2 high-entropy alloys95
Electrochemically alternating voltage induction and in-situ preparation of tin-based multiphase structures anode for sodium-ion batteries94
Investigation on high EMI shielding effectiveness and shielding mechanism of spherical Ti3C2Tx microfilm prepared by spray-freezing94
A two-step strategy for the preparation of ultra-small Mn3O4 @C anode for lithium-ion batteries93
Large magnetocaloric effect in gadolinium-rich silicate NaGd9(SiO4)6O293
Effect of Sc/Sm microalloying on microstructural and properties of Mg-2Zn-0.3Ca biodegradable alloy93
The effect of Sr doping on the structural, mechanical, electronic properties and radiation tolerance of MgAl2O4 spinel: A first-principles study93
Mechanism elucidation of Sn-Bi alloy lapping plate surface instability92
Facile room-temperature colloidal synthesis of CsPbBr3 perovskite nanocrystals by the Emulsion-based ligand-assisted reprecipitation approach: Tuning the color-emission by the demulsification process91
Zinc glycolate Zn(OCH2CH2O): Synthesis and structure, spectral and optical properties, electronic structure and chemical bonding90
Synthesis of NaNi0.5Mn0.5O2 cathode materials for sodium-ion batteries via spray pyrolysis method89
Tunable crystal structure of Cu2SnS3 deposited by spray pyrolysis and its impact on the chemistry and electronic structure89
Bimetallic MOF-derived oxides modified BiVO4 for enhanced photoelectrochemical water oxidation performance89
Boron nitride nanosheets decorated N-doped carbon nanofibers as a wide-band and lightweight electromagnetic wave absorber89
Modulation of magnetic and dielectric properties by Al3+ substitution in Ca3CoMnO6 ceramics89
Performance improvement of Li-rich Mn-based materials with the submicron-sized single-crystal morphology and cationic doping88
Humidity-independent gas sensor based on Pt/SnO2/NiO with advanced CO sensing capabilities88
Synthesis and high electromagnetic wave absorption performance of carbon-enriched porous SiOC ceramics88
0.14171099662781