Electrical Engineering

Papers
(The H4-Index of Electrical Engineering is 27. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-05-01 to 2026-05-01.)
ArticleCitations
Study on formation of dry band on wet polluted surface attached with float potential metal based on distributed parameter optimization simulation67
Real-time analysis of the associated currents of creeping discharge propagating over different liquid/pressboard interfaces under lightning impulse voltages57
Loss allocation in distribution systems considering system power factor and local generators54
Regional deep energy Q-Net-based energy scheduling for industrial energy management system54
Statistical switching method to establish the minimal requirements of insulation coordination in double-circuit transmission lines51
Transient forward harmonic adjoint sensitivity analysis48
Modified buck converter with constant voltage stress using a CDD circuit46
A novel scheme for distance and section estimation of steady-state faults in microgrids using voltage and current measurement at the beginning bus and the end buses of the microgrid46
50–60 Hz electromagnetic interference generated by power lines under fault condition: some probabilistic considerations45
A novel phasor-based adaptive single-phase auto-reclosing scheme for transmission lines with shunt reactors41
An efficient chaotic MHT-PUF-based IoT device authentication with QPBFT for smart grid infrastructure39
Novel deadbeat direct torque and flux control for interior permanent magnet synchronous motor39
Optimal loop power flow control of power distribution system using advanced meta-heuristic algorithms39
Future pathways for low-carbon technology integration in Wales’ electricity transmission and distribution networks38
Application of AdaBoost for stator fault diagnosis in three-phase permanent magnet synchronous motors based on vibration–current data fusion analysis38
The least squares off-line parameter identification method of half-dead compensated induction motor based on non-$$\frac{{k\pi }}{3}$$ angle37
Optimization of relay coil spatial position for a three-coil MCR-WPT system36
Stand-alone PV connected system with energy storage with flexible operation36
A comprehensive review of hybrid energy systems utilizing multilevel inverters with minimal switch count32
Research on the MMC-APF technique for optimal composite control of compensation currents based on multi-step model prediction31
Analysis of oscillation characteristics and internal dynamic interactions of grid-following converter31
A novel LSTM-based EMS and interleaved DC-DC boost converter topology for real-time driving conditions in HEVs31
STF-Net: a model for detecting transmission line fittings in UAV images29
Optimal operation of a microgrid with risk-averse information gap decision theory: enhancing profitability through uncertainty management29
Improved torque ripple minimization of SynRM with optimal multi-frequency harmonic current tracking28
A modified indirect vector control strategy for 3-phase wye-connected induction motor drives under open-phase fault28
Electromagnetic design and experimental validation of a low-power IPM motor27
Robust stator flux and load torque estimations for induction motor drives with EKF-based observer27
Switched capacitor-based 13-level multi-gain multilevel inverter with reduced switches and voltage stress27
Enhancement of the distribution network in the presence of EV charging stations augmented by distributed generation27
0.16804385185242