Marine Structures

Papers
(The TQCC of Marine Structures is 11. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-04-01 to 2025-04-01.)
ArticleCitations
Flexural strength and stiffness of circular double-skin and double-tube concrete-filled steel tubes90
Analysis of fatigue test data of retrieved mooring chain links subject to pitting corrosion62
Optimization of structural configuration and analysis of dynamic response using Absolute Nodal Coordinate Formulation for flexible hoses in deep-sea mining system59
Analytical formulations and comparison of collapse models for risk analysis of axisymmetrically imperfect ring-stiffened cylinders under hydrostatic pressure52
Hydrodynamic modeling effect analysis of a fully submerged tension leg concept integrating the DTU 10 MW offshore wind turbine51
Vulnerability criterion of nonlinear coupled resonance for semi-submersible platform using classification algorithm49
A face-contact connector for modularized floating structures45
Reliability-based structural design of a vertical subsea separator for deep-water applications44
A simulation-based and data-augmented shear force inversion method for offshore platform connector43
Epistemic uncertainties on the estimation of minimum air gap for semi-submersible platforms43
Comparative study of TLP and ETLP performance in Caspian Sea environment using numerical method41
Editorial Board40
Experimental uncertainty of a physical model of a tanker moored to a terminal in a port39
Investigation for the effect of the column step on the flow-induced motion of a TLP37
Probabilistic analysis of irregular wave runup on a fixed and truncated surface-piercing vertical cylinder37
Vortex induced vibrations of short side by side cylinders36
Obituary36
Editorial Board36
Editorial Board34
Passive control of jacket–type offshore wind turbine vibrations by single and multiple tuned mass dampers32
Numerical analysis and optimization of CFRP buckle arrestors in subsea pipelines31
Frequency-domain hydroelastic stress analysis considering local bending effect based on a two-step procedure31
A two-degree-of-freedom tuned mass damper for offshore wind turbines on floating spar supports30
Corrigendum to “Non-linear dynamic behavior of T0 and T90 mesopelagic trawls based on the Hilbert–Huang transform” [Marine Structures, Volume 100, 15 March 2025, 103727]30
Wave impact pressure and pressure impulse on a square column with an overhanging deck in regular waves30
Characteristics of gas explosion loads and structural responses of blast wall on FPSO30
Investigating the effects of Coating systems on the degradation behavior of 3D-Printed pressure vessels29
Estimation of directional wave spectra and hull structural responses based on measured hull data on 14,000 TEU large container ships29
Collapse of composite-repaired cylinders with internal metal loss subjected to external hydrostatic pressure28
Collar plate effect on local joint flexibility of tubular K-joints under IPB moments: Parametric study and predictive equations27
A finite element methodology for birdcaging analysis of flexible pipes with damaged outer layers27
Numerical simulation of wave-induced hydroelastic response and flow-induced vibration of a twin-tube submerged floating tunnel26
A deep learning model for predicting mechanical behaviors of dynamic power cable of offshore floating wind turbine26
On load-bearing and soil-reacting characteristics of hybrid pile-bucket foundations subjected to static horizontal loading25
Simplified bar-system model for tubular structures by considering local joint flexibility25
Rigid finite element method in applications to dynamic optimization of motion of a riser in reentry24
Parametric method for the assessment of fatigue damage for marine shaft lines24
Trapped waves within the blocking frequency under compressed sea ice and two-dimensional current24
The effect of the yield to tensile strength ratio on stress/strain concentrations around holes in high-strength steels24
Wave spectrum estimation conditioned on machine learning-based output using the wave buoy analogy23
On the influence of environmental and operational variability on modal parameters of offshore wind support structures23
Algorithmic formulation of clay and sand pipe–soil interaction models for on-bottom stability analysis23
Mechanical properties of marine polymer foams in the arctic environment22
Dynamic ultimate strength analysis of stiffened plate based on Idealized Structural Unit Method22
Dynamic response and performance of submarine tunnel subjected to surface explosions22
Editorial Board22
Numerical analysis of vortex-induced vibration on a flexible cantilever riser for deep-sea mining system22
A simplified non-linear numerical method for the assessment of welding induced deformations21
Influence of different combinations of impact mass and velocity with identical kinetic energy or momentum on the impact response of RC piles21
Environmental lumping for efficient fatigue assessment of large-diameter monopile wind turbines20
Multi-objective optimization of variable-stiffness composite for CFRP-winding buckle arrestor by using NSGA-Ⅲ20
Planar multibody dynamics of floating Y-method installation system and the lowering of subsea equipment based on finite element modeling20
Local joint flexibility of tubular T/Y-joints retrofitted with GFRP under in-plane bending moment20
Axial compressive strength of preloaded CHS stubs strengthened by CFRP19
The use of operational modal analysis and mode tracking for insight into polar vessel operations19
Size effect on residual stress in low transformation temperature welded joints19
Weld toe versus root fatigue failure mode and governing parameters: A study of aluminum alloy load-carrying fillet joints18
Coupled analytical-numerical approach for determining hydrodynamic responses of breakwater with multiple OWCs18
LQR control on multimode vortex-induced vibration of flexible riser undergoing shear flow18
Reliability analysis of ovalized deep-water pipelines with corrosion defects18
Directional wave spectrum estimation with ship motion responses using adversarial networks18
Prediction and mitigation of out-of-plane welding distortion of a typical block in fabrication of a semi-submersible lifting and disassembly platform18
Tuning of transfer functions for analysis of wave–ship interactions18
Application of analytical model in the prediction of dynamic responses and fatigue damage of flexible risers: Part II – Dynamic analysis of flexible risers in large-scale domain using a direct moment 18
A study on a representative heat source model for simulating laser welding for liquid hydrogen storage containers18
Three-dimensional vortex-induced vibrations of a circular cylinder predicted using a wake oscillator model18
Ultimate strength assessment of stiffened panel under uni-axial compression with non-linear equivalent single layer approach18
Field data observations for monitoring the impact of typhoon “In-fa” on dynamic performances of mono-pile offshore wind turbines: A novel systematic study17
Assessing the reliability of the cargo deck of a hovercraft through fiber optic strain measurements17
Vortex-induced vibration of a full-diamond textured cylinder at subcritical Reynolds numbers17
Response-based bridge deck limit state considering component-level failure under extreme wave17
Testing, simulation and design of offshore lined pipes under axial compression17
Methodology for the simulation of a ship's damage stability and ultimate strength conditions following a collision17
Three-dimensional equivalent static analysis for design of submerged floating tunnel17
Hydrodynamic interaction of floating bridge pontoons and its effect on the bridge dynamic responses17
An updated fast continuous contact detection algorithm and its implementation in case study of ice-structure interaction by peridynamics16
Experimental investigation of breaking regular and irregular waves slamming on an offshore monopile wind turbine16
Predicting heave and pitch motions of an FPSO using meta-learning16
Using the polynomial chaos expansion and bias-variance tradeoff to analyse the statistical characteristics of a trimaran cross-deck structure16
Hydroelastic analysis of Pre-Swirl Stator16
A Rayleigh-Ritz solution for high order natural frequencies and eigenmodes of monopile supported offshore wind turbines considering tapered towers and soil pile interactions16
Ice impact response and energy dissipation characteristics of PVC foam core sandwich plates: Experimental and numerical study16
Fatigue analysis of steel catenary risers under coupled cross-flow and in-line vortex-induced vibrations with oblique incoming flow16
A data-driven approach for fatigue life of water intake risers16
Study on hydrodynamic characteristics and depth control of the towed sensors array system16
FRF-based optimization strategies of actuator on/off status for active vibration isolation systems in underwater vehicle applications16
Assessing scour prediction models for monopiles in sand from the perspective of design robustness16
Cloud-based system for monitoring loads generated on the quay wall by ship propeller jets15
Dynamic behaviors of RC caisson subjected to underwater explosions15
Numerical investigation of flow-induced vibrations in two tandem circular cylinders at low gap ratios with considering collisions15
A modified p-y curve model for offshore piles near sandy slopes considering the soil-pile-slope deformation mechanism15
A low-fidelity model for the dynamic analysis of full-lattice wind support structures15
Numerical analysis on the creep-fatigue damage of titanium alloy deep-sea pressure hull at room temperature15
Reliability-based design optimization of river-sea-going ship based on agent model technology15
Accuracy verification of the 2D spectral AIS method by the hull monitoring data15
Remaining fatigue life assessment of corroded mooring chains using crack growth modelling15
Automated manufacture of optimised shape-adaptive composite hydrofoils with curvilinear fibre paths for improved bend-twist performance15
Structural optimization model of confined polyhedral composite subsea pipelines under pressure and thermal fields14
A Kane-based time domain hydrodynamic analysis method for hinged multi-floating bodies under irregular wave conditions14
Potential of a repair system for grouted connections in offshore structures: Development and experimental verification14
Experimental investigation of structural system capacity with multiple fatigue cracks14
Efficient optimization design method of jacket structures for offshore wind turbines14
Experimental investigation of nonlinear springing of ultra-large container ship in regular waves14
Stress concentration factors of multi-planar tubular KT-joints subjected to in-plane bending moments14
Design and experimental study of lightweight fireproof bidirectional bead bulkheads in a cruise ship14
Modelling of convection, diffusion and binding of chlorides in concrete during wetting-drying cycles14
Mechanical model and mechanical property analysis of fibre-reinforced hybrid composite pipes14
Numerical and experimental investigation on active hydraulic tensioner system for a TLP under tether fails condition14
Numerical modelling of hydrodynamic responses of Ocean Farm 1 in waves and current and validation against model test measurements14
Bond-slip behaviour of concrete filled double skin steel tubular (CFDST) columns14
Cargo ship aft panel stresses prediction by deconvolution14
Dilated-polyhedron-based DEM analysis of the ice resistance on ship hulls in escort operations in level ice14
Pressure-resistant cylindrical shell structures comprising graded hybrid zero Poisson's ratio metamaterials with designated band gap characteristics13
Pseudo-shakedown of rectangular plates under repeated impacts13
A general scaled model design method of stiffened plate subjected to combined longitudinal compression and lateral pressure considering the ultimate strength and collapse modes13
Data-driven modelling of fully nonlinear wave loads on offshore wind-turbine monopiles at prototype scale13
An experimental study of wave-in-deck loading and its dependence on the properties of the topside structure13
A Bayesian analysis for the quantification of strength model uncertainty factor of ship structures in ultimate limit state13
Uncertainties in modelling the low-frequency wave-induced global loads in ships13
Required test durations for converged short-term wave and impact extreme value statistics–Part 2: Deck box dataset13
An experimental investigation on interfering VIVs of double and triple unequal-diameter flexible cylinders in tandem13
A simplified approach to assess the resistance of a ship sliding on elliptic paraboloïd rock13
Dynamic response of a SWATH vessel for installing pre-assembled floating wind turbines13
Moored elastic sheets under the action of nonlinear waves and current13
A study for the bending vibration analysis of the intermittently welded stiffened plate13
Hoop and axial plastic buckling modes of submerged cylindrical shells subjected to side-on underwater explosion shock wave13
Hydrodynamic experiment of submerged floating tunnel under regular wave and current actions during construction period13
Active anti-rolling characteristics of fluid momentum wheel for cylindrical FPSO under wave conditions13
Editorial Board13
The impact of periodic axial loads on nonlinear dynamic instability behavior of Inconel 625 pipes13
Design considerations of drag anchors in cohesive soil for floating facilities in the South China sea12
Development of an integrated deep learning-based remaining strength assessment model for pipelines with random corrosion defects subjected to internal pressures12
Hydrodynamic modelling of a multi-body wave energy converter using the Moving Frame Method12
PSO-based design and optimization of jacket substructures for offshore wind turbines12
Fully 3D ship hydroelasticity: Monolithic versus partitioned strategies for tight coupling12
Editorial Board12
Uncertainty in wave hindcasts in the North Atlantic Ocean12
Editorial Board12
Methodology for developing a response-based correction factor (alpha-factor) for allowable sea state assessment of marine operations considering weather forecast uncertainty12
Analysis of safety and impact probability of subsea Christmas tree impacted by falling objects12
Impact of climate change on the design of multi-megawatt spar floating wind turbines12
Editorial Board12
Axial buckling behavior of H-piles considering mechanical-electrochemical interaction induced damage12
Flexural response of composite coated steel components using the extended finite element method12
Vortex-induced forces of crossflow and inline oscillating bluff bodies at moderate Reynolds numbers12
Investigation of higher-order springing of a ship in regular waves by experimental analysis and two-way CFD-FEA coupled method12
Statistical modelling of the ocean environment – A review of recent developments in theory and applications12
A numerical study on the correlation of ductile crack extension in Ni-based clad pipe girth welds with circumferential surface cracks and clamped SE(T) specimens12
Editorial Board12
Experimental investigation of downstream cylinder vibrations caused by FIV in the presence of upstream stationary cylinder12
Experimental study of multi-buoy-assisted moored ship motion at open berth12
A probability-based study on failure mechanism and quantitative risk analysis for buried offshore pipelines subjected to third-party impact loads, exploring the effects of spatial variability of soil 12
Investigation on fatigue characteristics of transparent submersible manned cabin structure11
ABAQUS–OlaFlow integrated numerical model for fluid–seabed–structure interaction11
A goal-based approach for selecting a ship's polar class11
Modeling and calculation of acoustic radiation of underwater stiffened cylindrical shells treated with local damping11
Study of collision characteristics of water-filled double-layer structure11
Identification of stiffness and damping of the weld in stiffened plates using model updating11
The DeRisk database: Extreme design waves for offshore wind turbines11
Integrated optimisation design of a dynamic umbilical based on an approximate model11
Collapse behavior of carbon-fiber epoxy cylinders subjected to long-term seawater exposure at seafloor depth pressures11
Lateral static stiffness of offshore monopile socketed in soft rock11
Understanding the higher harmonics of vortex-induced vibration response using a trend-constrained, machine learning approach11
Experimental study of liquid slamming in elastic rectangular tanks under the flip-through impact11
The ISSC 2022 committee III.1-Ultimate strength benchmark study on the ultimate limit state analysis of a stiffened plate structure subjected to uniaxial compressive loads11
Influence of different topological variants on optimized structural scantlings of passenger ship11
A numerically efficient framework in failure mode evaluation of a wind turbine tower under cyclones11
The remedial performance of suction caisson foundations for offshore wind turbines under seismically induced liquefaction in the seabed: Shake table testing11
The effects of geometric detail on the vibratory responses of complex ship-like thin-walled structures11
Study on the energy dissipation mechanism of the pyramidal lattice sandwich panel subjected to underwater explosion11
Mooring system stiffness: A six-degree-of-freedom closed-form analytical formulation11
0.10447287559509