OOIR: Observatory of International Research

Papers

(The H4-Index of Journal of Prosthodontics-Implant Esthetic and Reconstructive Dentistr is 25. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-08-01 to 2026-08-01.)

Article	Citations
Effect of intraoral scanning distance on the marginal discrepancy of milled interim crowns	151
	113
Worn denture teeth of a full‐arch implant‐supported fixed dental prosthesis: A technique to restore	83
Assessing the influence of titanium dioxide nanotubes incorporation on thermal and thermomechanical characteristics of 3D‐printed denture base resin	70
Clinical reproducibility of different centric relation recording techniques in edentulous individuals: An observational cross‐sectional study	65
Retention degradation of two milled bar systems versus solitary attachments for implant mandibular overdentures: An in vitro study	63
Validation of a novel implant‐retained fiducial marker system for digital scan alignment in the edentulous mandible: An accuracy study	63
CPP‐ACP paste's effect on salivary conditions in patients with removable dentures	48
Digital workflow of labial guides for alveolar ridge reduction during implant‐supported full‐arch rehabilitation	46
Flexural strength of high yttrium oxide‐doped monochrome and multilayered fully stabilized zirconia upon various sintered cooling rates	45
Application of organoselenium in inhibiting Candida albicans biofilm adhesion on 3D printed denture base material	44
Advancing maxillofacial prosthodontics by using pre‐trained convolutional neural networks: Image‐based classification of the maxilla	43
Effect of resin cement type and autoclaving on the retention of zirconia on Ti‐base abutments	43
Effect of abutment type and creep behavior on the mechanical properties of implant restorations in the anterior region: A finite element analysis	40
Marginal gap of printed, milled, and heat‐pressed two‐piece polyetheretherketone abutments before and after thermal cycling, and their pull‐off bond strength after thermal cycling	39
Immediate loading of implants inserted in implant beds prepared with conventional or ultrasonic osteotomy in the esthetic zone: Randomized clinical trial with 12‐month follow‐up	33
Reverse scan body: Complete digital workflow for double full‐arch zirconia prostheses	32
Influence of occlusal thickness and aging on the fracture load of additively manufactured definitive crowns in different resins	30
Custom fabricated three‐dimensional printed surgical guide for trephine bur in autogenous bone graft: A technique report	28
Comparative assessment of bleaching of natural teeth using ozone‐enhanced low‐concentration hydrogen peroxide	26
Effect of finish line location and saliva contamination on the accuracy of crown finish line scanning	26
	25
	25
Issue Information ‐ Editorial Board	25
Is the clinical performance of internal conical connection better than internal non‐conical connection for implant‐supported restorations? A systematic review with meta‐analysis of randomized controll	25