Journal of Thermal Spray Technology

Papers
(The H4-Index of Journal of Thermal Spray Technology is 27. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-11-01 to 2025-11-01.)
ArticleCitations
Sensitivity Analysis of Process Parameters of Warm Spraying Process Based on Response Surface Method78
Wear Mechanisms of Cold-Sprayed Stellite-6 During Reciprocated Dry Sliding Under Different Sliding Speeds72
Mario Guagliano, Vincent Rat, and Katy Voisey Join JTST Editorial Team71
Thanks to Our Guest Editors and Reviewers for Their Critical Contributions in 202267
Incorporation of TERGO and EG in Plasma Sprayed Ceramics Coatings for Improved Microwave Absorption and Tribological Properties65
Effects of Different Laser Powers on the Structure and Properties of In Situ TiC-Enhanced Ni-Based Coatings63
Journal of Thermal Spray Technology Announces Editorial Transition59
Journal of Thermal Spray Technology Announces Revised Aims and Scope57
Correction to: Preparation of Plasma Sprayed GDC Electrolytes for Metal-Supported Solid Oxide Fuel Cells53
Effect of TiC on the Microstructure and Properties of FeCoNiCrMo High-Entropy Alloy Coatings by Plasma Cladding50
Effect of Scanning Rate on Microstructure and Properties of Fe-Based Amorphous Composite Coatings Prepared by Laser Cladding under Constant Heat Dissipation48
Novel Method of Predicting Deposition Efficiency in Cold Spray by Incorporating Sphericity into a 1D Analytical Model46
Microstructure and Properties of Nickel-Clad Cubic Boron Nitride-Reinforced Ni-Based Composite Coating Laser Cladding on Martensitic Stainless Steel Substrates44
Preparation and Performance of Conductive Ti4O7 Coatings on SS316L Bipolar Plates37
Effect of Laser Remelting on the Microstructure and Properties of Fe-Based Amorphous Coatings36
Development of Single-Stage TiNbMoMnFe High-Entropy Alloy Coating on 304L Stainless Steel Using HVOF Thermal Spray34
Investigating the Influence of Heat-Treated Powder Microstructures on Particle Bonding and Tensile Response in Cold-Sprayed AA707533
Characterization and High-Temperature Fretting Wear Resistance of HVOF-Sprayed Cr3C2-NiCr, CoCrWC and CoCrWNiC Hardfacing Coatings33
Properties of Al0.5CoCrFeNi2Ti High-Entropy Alloy System: From Gas-Atomized Powders to Atmospheric Plasma-Sprayed Coatings32
An Overview of Thermally Sprayed Fe-Cr-Nb-B Metallic Glass Coatings: From the Alloy Development to the Coating’s Performance Against Corrosion and Wear31
Wear and Corrosion of HVAF and HVOF-Sprayed WC-CoCr Coatings on Aluminum Alloy30
Subsurface Weave Pattern Influences on Polymer Cold Spray Deposits onto Woven Fiber-Reinforced Composites30
Forming Behavior of Additively Manufactured Al/Ti Material Compounds Produced by Cold Spraying30
Preparation of Plasma Sprayed GDC Electrolytes for Metal-Supported Solid Oxide Fuel Cells29
Effect of Impact Angles and Temperatures on the Solid Particle Erosion Behavior of HVOF Sprayed WC-Co/NiCr/Mo and Cr3C2-CoNiCrAlY Coatings28
Microcrack Morphology in the Thermal Insulation Performance of 8YSZ Thermal Barrier Coatings: A Mesoscale Numerical Study28
In Situ Synthesis of FeAl Intermetallic Coatings by Wire Electrical Explosion-Spraying27
0.15493607521057