Journal of Optical Technology

Papers
(The TQCC of Journal of Optical Technology is 1. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-10-01 to 2025-10-01.)
ArticleCitations
Wide-angle concentric mirror lens objective19
Holographic technologies today and tomorrow12
Effect of the electrical formation of electrochromic devices based on tungsten oxide12
Laser removal of foxing from the pages of books and paper documents10
Image reconstruction based on a single-pixel camera and left optimization8
Editor’s foreword for this special issue8
Heterodyne straightness interferometer with reduced periodic nonlinearities8
Mathematical modeling of the parameters of an electro-optic modulator in the Mach–Zehnder interferometer configuration based on thin lithium niobate films6
Highly sensitive laser probing and structural diagnostics of ordered substances, materials, and micro- and nano-systems [Review]6
Surface-enhanced optical absorption and induced heating in tapered silicon nanoprobes5
Analysis of data from biomedical multisensor optical systems5
Development and research on narrowband spectral filters on a cascade of fiber Bragg gratings5
Effect of speckle rotation on the interference of optical vortices and waveguide modes of an optical fiber5
Vadim Glezer’s modules model as a possible basis for vision perception description5
Acousto-optic spatial frequency filter operating in the intermediate region of acousto-optic interaction4
Environmentally stabilized thermal-imaging optical systems4
Position coding as a means of increasing the range of optical communications links4
Inertia of the oscillatory mechanisms of giant nonlinearities of optical materials in the terahertz spectral range4
Scintillation optical-electronic converter of gamma radiation based on a silicon photomultiplier4
Optical properties of InGaP(As) quantum dots in GaAs/AlGaAs/InGaP/InGaAs heterostructures4
Feature detector for space hyperspectral images4
Femtosecond laser-based absolute rangefinder with the possibility of traceability to the time and frequency standard4
Simulation of the operation of a distributed fiber-optic current sensor using Brillouin scattering4
Attenuation of a single pulse of a neodymium laser in colored optical glasses3
Low-noise suppression algorithm based on a single shot for laser complex amplitude measurements3
Precision replication of all types of optical surfaces—scientific and technological basis for the radical transformation of modern optical production3
Characteristics of various sensor devices for a miniature resonant optical gyroscope3
Hardware and software complex for the detection and identification of informative features in images of means of nonverbal communication3
In memory of Yuri Alexandrovich Rezunkov—19 October 1950–31 March 20233
Classification of objects and scenes by a neural network with pretrained input modules to decode spatial texture inhomogeneities3
Development and analysis of a fiber-optic temperature sensor based on two superposed regenerated fiber Bragg gratings3
Neural-network-based methods in digital and computer-generated holography: a review3
Performance optimization of an intersatellite optical wireless system using linearly polarized modes3
Line-of-sight and non-line-of-sight vehicle-to-vehicle communication using light fidelity3
Minimum number of stages in a GaAs/AlGaAs terahertz quantum cascade laser with a metal-to-metal waveguide3
Changes in optical thicknesses of Ge and SiO thin films and spectral characteristics of narrowband filters at cryogenic temperatures3
Photo-thermo-refractive glass: a promising photonics material [Review]3
Random number generator based on semiconductor nanoheterostructures with quantum dots and optical feedback3
Analysis of sectorial synthetic HPHT diamond plates by laser-induced breakdown spectroscopy considering similarity of ablation processes3
Image curvature assessment in the presence of distractors3
Growth and characterization of nBn structures based on CdxHg1–xTe for photodetectors in the 3–5  µm spectral range3
Laser control channels with diffractive optical elements for optical system alignment3
Stand for measuring the residual reactive moment of optical-mechanical systems2
Characterization of gap-plasmon-based metasurfaces with scanning white-light interferometry2
Database of video images of natural emotional facial expressions: perception of emotions and automated analysis of facial structure2
Ghost polarimetry with a spatial light modulator for creation of structured illumination patterns2
Algorithm for modeling the optical system of an individual’s eyes using the location of the far point for clear vision2
Evaluating and testing neural-network algorithm capabilities for automating image data analysis for remote sensing of the Earth2
Effect of the products generated by the vacuum ultraviolet photolysis of water on the survival of microorganisms2
Laser plasma–chemical treatment of optoelectronic materials2
Modification of the optical and electrical properties of lead selenide films by using nanosecond laser pulses with a wavelength of 1.064  µm2
Comparative analysis of design algorithms for optical systems using composite holographic optical elements2
G. I. Greĭsukh and L. A. Gubanova recognized as best reviewers of 2022 by the Editorial Board of Opticheskiĭ Zhurnal2
Method for achieving magneto-induced non-reciprocity in resonant silicon waveguides with violated mirror symmetry2
Changes in the spectrum and structure of polariton modes in a class C laser induced by distributed feedback2
Diffractive microstructures of zoom lenses for visible and near-infrared ranges based on novel optical plastics2
Foreword by the issuing editors2
Characterization of lasing regimes of 1.3  µm vertical-cavity surface-emitting lasers based on a short-period InGaAs/InGaAlAs superlattice2
Influence of scattering light on optical systems’ quality characteristics2
Formation and practical implementation of a helical radiation wavefront in the mid-infrared range2
Image processing technique for measuring the weld dilution and heat-affected zone to model the gas metal arc welding process by a neuro-fuzzy system2
Fiber-optic method for identification of various substances by their thermal characteristics2
Noninvasive polarization-based technique for hematocrit monitoring2
Modeling and optimization of optical designs with composite holographic elements2
Deepfake as the basis for digitally collaging “impossible faces”2
Quantitative evaluation of the functional activity in multilayered brain structures using histological sections2
Holographic methods of image transmission over multimode optical fiber for increased bandwidth of fiber-optic communication lines2
Parametric laser rangefinder with a passive thermal stabilization system2
AlGaN-based laser diodes with reduced Al composition in quantum barriers in the deep ultraviolet region2
Fusion splicing of hollow-core to standard single-mode fibers using a gradient-index bridge fiber1
Simple optical criterion of the ripeness level of strawberries1
Routing subcarrier wave quantum key distribution through a metropolitan optical transport network1
Systems of generalized harmonic lenses for image formation1
Deposition of laser antireflection coating by a silicate sol-gel process1
Identification of the Hermite-Gaussian and Bessel modes of a terahertz beam with diffractive optical elements1
Influence of laser pulse duration on fused silica treatment using laser-induced microplasma1
Reflectivity of optical glasses in the mid-infrared spectral range in a humid atmosphere1
Super-resolution microscopy based on denoised conventional raw images with wide spectrum denoising1
Formation and properties of volume and relief holographic gratings in photopolymer materials1
Foreword by the issuing editor1
Suppression of residual amplitude modulation in diffused-channel Ti:LiNbO3 optical waveguides by changing their geometry1
Current mode of photomultiplier tube operation for the detection of the kinetics of small optical signals1
Stability of the properties of an acousto-optical converter based on polyvinylidene fluoride films under external influence1
Method for recording holograms that form a speckle-free image of the aiming mark in holographic collimator sights and other similar augmented-reality devices1
Development of a fiber-optic temperature sensor based on chirped Bragg gratings and modulation of optical radiation intensity1
Time-varying materials for analog optical computing1
Model and algorithm for calculating the irradiation of a space object by Earth’s radiation1
Two-component compensators of field aberrations of optical systems1
Calculation of blood flow parameters in zebrafish larvae using the phase correlation method1
Increasing the measurement accuracy for wave aberrations of an optical system using the intensity distribution of a focused light beam1
Modulation transfer function and effective diffusion length of photogenerated charge carriers in mercury-cadmium-telluride focal-plane diode arrays with different values of geometric parameters1
Collimation of an anastigmat objective with three off-axis aspherical mirrors1
Application limitations of a laser guide star in adaptive optoelectronic systems caused by its jitter in the atmosphere1
Foreword by the issuing editor1
Synthesis of freeform optical surfaces using neural networks1
Luminescence response of neodymium ions to phase transformations in yttria-based solid-solution nanopowders1
Features of colored object detection by a person compared with using hyperspectral technology1
Effect of neodymium ions on the parameters of volume Bragg gratings recorded in chlorine- containing photo-thermo-refractive glasses1
Parametric optimization of silicate-glass-based asymmetric two-beam laser splitting1
Quantum dots: the birth of nanotechnology1
Analysis of phase noises in the laser interferometer for the SOIGA gravitational wave detector project1
Production of nanoporous silicate matrices—problems of optical homogeneity1
Laser-induced improvement of the photoelectric characteristics of ZnO:Ag thin films1
Research on the performance of a fiber optical current transformer for high voltage filtering capacitor unbalanced current measurement1
In memory of John Sheridan (1964–2022)1
Foreword by the issuing editors1
Estimation of tolerance on the image stabilization accuracy of on-board automatic optoelectronic aiming devices1
Enhancing the accuracy of length measurements using laser phase rangefinders1
Influence of technological parameters on the characteristics of photosensitive structures based on metal phthalocyanine using a non-fullerene acceptor1
Multispectral video camera optical system1
Improving the efficiency of solar cells based on CsSn0.5Ge0.5I3 perovskite by using ZnO nanorods1
Recognition of 3D objects in a monostatic laser location system via intelligent analysis of pulsed reflectance profiles1
Optical methods for measuring the thickness of thin evaporating liquid films1
Development of an afterpulse effect model of InGaAs/InP single-photon avalanche diodes for application in quantum key distribution systems1
Study on a plane grating spectral imaging system with smile and keystone eliminated1
Aberration analysis of decentered lenses for the compensation of vergence–accommodation conflict in virtual reality systems1
Technology for developing a high-aperture four-mirror lens with aspherical mirrors1
Use of Raman spectroscopy for assessment of changes in enamel and dentin composition after in-office whitening1
Structure and optical properties of glasses in the As-Se system1
Dependence of the quantum yield of upconversion luminescence emitted by powdered NaYF4:Yb,Er samples on ytterbium-ion content and excitation intensity1
High-quality telecentric projection lens for vein visualization1
Simultaneous generation of N coherent pulses of various areas under self-diffraction in87Rb vapors1
Ultrafast spatial scanning by pulse-periodic chirped laser radiation along two orthogonal coordinates1
Evaluation of the thermal contrast of low-temperature ground-based objects1
Dynamic range of a coherent optical spectrum analyzer with a liquid-crystal matrix signal-input device1
Design and performance analysis of a deterministic iSWAP gate using a resonator as a coupler1
Nanosized quartz of shungite rocks1
Ex vivo determination of perfusion-kinetic parameters in ovaries with granulosa cell carcinoma using reflectance spectroscopy1
Modeling of photoelectric characteristics and development of structures for solar cells based on CsPbI3 and CsPbBr31
Ultra-high-sensitivity gas pressure sensor based on a cascaded Fabry-Perot interferometer and the Vernier effect1
Acousto-optically controlled optical tweezers1
Segmentation of visual images: experimental data and modeling1
Fiber Bragg grating security fence with temperature compensation based on a tilted cantilever beam1
Matrix measurement technology: accuracy of measuring element coordinates and photomask control1
Model parameters of a horizontal seismometer with an optical diffraction vibration sensor1
High-power p-i-n photodiode for the 1300–1550  nm spectral range with 0.5  A/W sensitivity at 50  mW optical power1
Surface relief holograms: state of the art and current development prospects1
Optical camera communications: practical constraints, applications, potential challenges, and future directions1
0.09264612197876