European Physical Journal-Applied Physics

Papers
(The TQCC of European Physical Journal-Applied Physics is 2. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-07-01 to 2025-07-01.)
ArticleCitations
Tuning the optoelectronic properties of AZO thin films for silicon thin film solar cell applications25
Research on a permanent magnet assisted synchronous reluctance machine with hybrid excitation22
Calculation of structural, electronic, magnetic and optical properties of C3N monolayer substituted with magnesium17
The effects of the electric-magnetic barrier on the spin transmission in the multibarrier semiconductor heterostructures15
Study of the corrosion inhibition of C38 steel in a 1M HCl medium by the ethanolic extract ofRumex Nervosus Vahl leaves14
Growth of size-matched nanoalloys – a comparison of AuAg and PtPd12
The adsorption of methylene blue from wastewater by Moringaoleifera pods and kernels wastes using the response surface methodology12
Transition from laminar to chaotic natural convection of air saturating a porous square enclosure11
In situ TEM study of crystals growth in amorphous Ti-Zr-Ni films at electron beam irradiation9
MRT-LBM simulation of natural convection in square annulus with a porous coating: route to chaos8
Study of spatially confined copper plasma by probe beam deflection technique8
Barium cerate and its composite perovskites – synthesis techniques: a comprehensive review7
Modification of structural, thermal and optical properties of PC-PET/CdSe NCP using gamma radiation7
Transition metal doping and co-doping effect on electronic and magnetic properties of zb-ScN6
Central vacancy creation in icosahedral nanoparticles induced by the displacement of large impurities6
Comparison of structural heterogeneity in Zr- and Pd-based metallic glasses6
Evaluation of electrical conductivity of Fe-doped forsterite ceramics synthetized by sol–gel method5
Retraction Notice: Interpretation of Stark broadening measurements on a spatially integrated plasma spectral line5
Thermo-mechanical energy harvesting and storage analysis in 0.6BZT-0.4BCT ceramics5
Tailoring Li2SO4‒MgO‒P2O5 glasses for electrodes and electrolytes in solid ‒ state batteries with CoO doping by means of dielectric studies5
Transformation of mineral matter during pyrolysis, gasification and combustion of biosolid chars5
First-principles computation of hydrides-perovskites XZrH3 (X = Ba, Ca, and Sr): evaluation of structural, electronic, optical and mechanical properties for hydrogen storage5
Effect of annealing on photo-physical properties of BiI3 thin films via vacuum thermal evaporation deposition for photovoltaic applications5
Nanoporous structures with Fe0/FeII/FeIII co-existed as catalysts for phenol degradation4
Effect of the physical aging on the secondary β relaxation process in a La-based metallic glass4
Photosensing properties of zinc nitride thin-film transistors fabricated on recyclable plastic substrates4
Research on ac copper losses in permanent magnet electrical machines with hairpin windings for automotive applications4
Combustion synthesis of KZnPO4: RE (RE = Dy3+and Sm3+) Phosphors for n-UV based w-LEDs4
Modelling the statics and the dynamics of fluctuations in the ordering alloy AuAgZn23
Editorial for the Special Issue on amorphous alloys and multiscale materials: fundamental aspects and energy applications3
The effects of Pt doping on the optical properties of Au203
Validation using the in vivo experiment of the 3D model of the human ear using the equivalent mechanical impedance of the Mass-Spring-Damper System3
Experimental and numerical studies of stress fields of a branched polybutadiene in a flat die3
Bright sources under the projection microscope: using an insulating crystal on a conductor as electron source3
Morphology of metallic foams synthetized by plasma electrolysis deposition3
Comparative study of solar tracking and fixed-tilt photovoltaic modules in Morocco3
Erratum to: Impact of damaging and recovery on the temperature dependence of the work function of oxide electrodes in fluorescent lamps3
Effects of monolayer and bilayer silica films on Fe-Phthalocyanine adsorption properties3
Phase-shifting digital holography with an unknown reference beam3
Antibacterial activity of Nickel-doped ZnO/MWCNTs hybrid prepared by sol–gel technique3
Out-of-equilibrium supported Pt-Co core-shell nanoparticles stabilized by kinetic trapping at room temperature3
Edge-Detected 4DSTEM - effective low-dose diffraction data acquisition method for nanopowder samples in an SEM instrument3
Complex-frequency approaches for parallel computations of the eddy-current transient response3
From early to present and future achievements of EELS in the TEM3
Hematite based ultrafiltration membrane prepared from pyrrhotite ash waste for textile wastewater treatment3
Structural and Optical characterization of gamma irradiated PVA-PEG/Cr2O3nanocomposite films3
Effect of vacuum annealing on the properties of one step thermally evaporated Sb2S3thin films for photovoltaic applications2
Improving dielectric properties of composites thin films with polylactic acid and PZT microparticles induced by interfacial polarization2
Synthesis and structural, morphological, and chimico-optical properties of Sr2FeO4 Ruddlesden-Popper oxide2
Review of EELS over the last 50 years by Christian Colliex2
Effect of Cu doping on the electronic structure, magnetic and optical properties of GaN/ZnS heterojunctions: a first-principles study2
Na-doping approach for conductivity enhancement of natural phosphate derived fluorapatites2
Anatase TiO2 film with dominant (001) facets prepared by radio frequency atmospheric pressure plasma2
Flower-like 3D MoS2/Cu2O hybrids with enhanced photoelectrochemical performance2
A simple method to calculate incident dose for the proximity effect correction2
Analysis of complex impedance spectroscopy, modulus and dielectric properties of the 0.65PbMg1/3Nb2/3O3–0.35PbTiO3 perovskite single crystals2
Acoustophoresis separation of particles based on motion modes via tilted-angle standing surface acoustic wave driven by a unidirectional transducer2
A novel 5d-7f transition phosphor KAl1–xPO4Cl:Tbx3+ (0.1 ≤ x ≤ 1.0)2
Analysis of superconducting silicon epilayers by atom probe tomography: composition and evaporation field2
A type-II GeSe/SnTe heterostructure with superior optical absorption and strain tunable photovoltaic properties2
Special issue on advances in renewable energies, materials and technology2
Interpretation of temperature measurements by the Boltzmann plot method on spatially integrated plasma oxygen spectral lines2
Interpretation of Stark broadening measurements on a spatially integrated plasma spectral line2
Vibration analysis of a composite elastic metamaterial plate based on a semi-analytical method2
Perovskite solar cell with SnO2 mesoporous thin films as electron transport layer: facile fabrication, investigation of the effects of growth parameters2
Influence of different terminations on the surface properties of rare earth sesquioxides: first-principle calculations2
Microstructure and mechanical properties of particle reinforced high-temperature titanium composites2
Erratum to: Cold starting of fluorescent lamps − part II: experiments on glow times and electrode damaging2
On the effect of concentration and wettability on polymer drops impact, dynamics and energy dissipation2
Identification of wood specimens utilizing fs-LIBS and machine learning techniques2
Shaping the topology of a single phase BLDC motor for reduced cogging torque and improved performance2
Interpretation of Stark broadening measurements on a spatially integrated plasma spectral line2
Synthesis, characterization, and optical properties of NiCr2O4 and CoCr2O4 spinel nanostructures for photocatalytic applications2
Estimation of the drying process in porous media using the parallel and series moitrue transfer model2
Review on recent advances in cold plasma technology2
Investigating the structural, electronic, and magnetic properties of Cd1–xVxTe: insights from first-principles calculations2
Characterizing the physicochemical and mechanical properties of ZrN thin films deposited on Zr substrates by pulsed laser technique2
Significant effect of SDS on the optimum operating temperature of ZnO nanosheets gas-sensitive materials2
Computational study of partial discharge events in electric drives with segmented power supply2
Optical, impedance, and relaxation response of Fe3+ doped double perovskite solid solution2
Characterisation of the waveplate associated to layers in interferential mirrors2
Regulation of electrical properties of ZrOxNy by oxygen doping and zirconium vacancies2
Advances in atomic resolution secondary electron imaging2
0.092066049575806