OOIR: Observatory of International Research

Papers

(The TQCC of Corrosion Engineering Science and Technology is 4. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-11-01 to 2025-11-01.)

Article	Citations
Corrosion failure analysis of nuts and locking device assembly at airliner hatch door rods	37
Optimising the corrosion performance of hot-rolled steel bar in concrete	27
Localised corrosion assessment of friction-stir welded AA7050-T76511 alloy: galvanic interactions and microstructural effects	25
Effect of boron and nitrogen on the corrosion properties of modified 9Cr–1Mo steel in alkali and chloride medium	20
Magnetic field-induced codeposition of (Ni–Co) alloy coatings for better corrosion protection	19
A new strategy to improve the anticorrosion performance of waterborne polyurethane coating on AA7075	18
Non-destructive techniques for corrosion detection: A review	17
Enhanced corrosion protection of AZ31B magnesium alloy by MgAl-LDHs composite coatings double-doped with imidazolium ionic liquid and sodium dodecylbenzenesulphonate	17
Corrosion analysis of vehicle materials and feasibility assessment of magnesium alloys under deicing agent exposure	13
Impact of wet-dry cycle on the corrosion of grounding down leads in saline soil	12
A chloride deposition model for predicting the categories of atmospheric corrosivity in coastal areas	11
Effects of organic metabolites of sulfate-reducing prokaryote on corrosion of AZ31B magnesium alloy	11
The bifunctional role played by thiocyanate anions on the active dissolution and the passive film of titanium in hydrochloric acid	11
Investigation of anti-corrosion performance of ZIF-8/Zn(OH)F composite films on Zn–Al coating	11
Effect of strain-induced martensite reverse transformation on microstructure evolution and electrochemical behaviour of 2304 lean duplex stainless steel	11
Enhancing corrosion resistance in HCl environments: Comparative efficacy of a conjugated 3ph-Schiff base versus benzotriazole	10
Effect of hot extrusion on AZ91 alloy corrosion behaviour	10
Understanding imidazole derivatives effect as a corrosion inhibitor for brass in nitric acid: a combined experimental and theoretical assessments	9
Crevice corrosion behaviour and mechanism of laser additive manufacturing nickel-based alloy by using wire beam electrode	9
Effect of ultrasonic impact treatment on corrosion fatigue performance of friction stir welded 2024-T4 aluminum alloy	9
Comparative corrosion behaviour of different alloys for nitric acid service in reprocessing plants	9
Synthesis of layered double hydroxides for anti-corrosion coatings on magnesium alloys: A review	9
Effects of low temperature aging on microstructure and corrosion behavior of Mg-6.5Gd-0.9Y-0.5Zr alloy	8
Effect of crystal structure of matrix layers on microstructure, texture and corrosion characteristics of multilayered composites	8
An overview of progresses and challenges of electrochemically integrated multi-electrode arrays for probing localised corrosion in complex environmental conditions	8

Electrochemical corrosion behavior of S31254 stainless steel in simulated desulfurization flue gas condensates	8
Methodology for ranking internal corrosion-induced leakage susceptibility in oilfield pipelines	8
Geo-mapping atmospheric corrosion in Mauritius	8
Effect of the temperature on the passivity of the modified martensitic stainless steels	8
Vibratory polishing effects on passivity of 304L stainless steel surfaces	8
Experimental study on passivation and corrosion performances of pre-rusted steel in simulated concrete pore solution	8
Polyvinyl alcohol (PVA) as a biodegradable polymeric anticorrosive material: A review on present advancements and future directions	7
Corrosion behaviour of 110SS steel in hydrochloric acid–acetic acid composite system	7
Study of high-frequency impedance of zinc-rich coatings	7
Corrosion resistance of a super-hydrophobic dodecyltrimethoxysilane-based polypropylene coating on magnesium alloy AZ31	7
FEM simulation of a grounded carbon steel pipe under impressed current cathodic protection	7
Effect of CO₂ content on corrosion non-uniformity of 20# steel in oil–water two-phase based on wire beam electrode technique	7
Effect of Ai–Si coating weights on corrosion of ultra-high-strength steel Usibor^R 1500 used in automotive structures	6
Flash butt welding corrosion of mooring chains	6
Vapour phase assembly of ultrathin coatings from alanine ternary complex on the carbon steel surface with enhanced corrosion resistance	6
Study on the corrosion and damage behaviours of P110 tubing of deep shale gas wells	6
Investigation of corrosion behaviour on Ni–Cr–Co and Ni–Cr–Mo alloys exposed to molten salt for thermal energy storage applications	6
Corrosion performance of carbon steel and 304 stainless steel in activated methyldiethanolamine solution using autoclave tests	6
Effect of Cu addition on the mechanical properties and corrosion behaviours of Al–9.2Mg–0.8Mn alloy	6
Effect of a cement-bentonite grout on AVM glass alteration and C-steel corrosion at nanometer scale	6
Cyclic oxidation and hot corrosion performance of direct metal laser sintered and wrought alloy 718 at 800°C in air and molten salts containing Na₂SO₄, V₂O₅	6
Chemistry conditions and corrosion behaviour in simulated crevices of alloy steel	6
Electrochemical and microstructural analysis of reinforcement corrosion in concretes exposed to cyclic chloride-carbonation conditions	6
Laser surface melting of 304L SS: increase in resistance to transpassive dissolution and pitting corrosion	6
Localised aqueous corrosion of electroless nickel immersion gold-coated copper	6
Stress corrosion crack propagation behaviour of MAO ceramic coating on Mg alloy	5
Inhibition effect of nano-silica synergistic corrosion inhibitor on 110SSsteel in ultra-high temperature organic acidic environment	5
Effect of Y₂O₃ nanoparticles on microstructure, corrosion resistance and hardness of Ni–W/CeO₂ composite coatings	5
The effect of deformation and heat treatment on the mechanical properties of bimetallic clad pipe	5
Structure and improved corrosion properties of MAO coating on Mg-5Gd-1Zn-0.4Zr formed under various current densities	5
Negative effect of Hf and Zr co-doping on alumina film growth of nickel-aluminium single-crystals during thermal cyclic oxidation	5
Si segregation and relevant effect on the corrosion propagation in F/M steel exposed to liquid lead-bismuth eutectic	5
Electrochemical and molecular modelling studies of corrosion inhibition characteristics of imidazolines on 1Cr steel under sweet conditions	5
Biogenic corrosion inhibition through Bacillus coagulans on mild steel in mild acidic medium	5
Effect of the oxidation reaction interface on the accelerated corrosion behaviour of Al–Mg–Si alloy	5
A study on the durability of high hardness steels subjected to environmentally assisted hydrogen embrittlement	5
Assessing coating integrity and cathodic protection on buried pipelines under horizontal directional drilling conditions	5
Effect of grain structures and precipitation characteristics on the corrosion behaviour of Sc-containing Al-Cu-Li alloy	4
Evaluation of corrosion behaviour of turmeric-coated AZ51 alloy in simulated body fluid for biomedical applications	4
Biofuels-related materials deterioration in biorefineries, transportation and internal combustion engines: a technical review	4
Tony Mercer, BSc, FICorr (21 November 1928–20 October 2020)	4
Numerical analysis of topographic and Volta potential profiles during corrosion of duplex stainless steel in chloride solution	4
Effect of hydrostatic pressure on galvanic corrosion of low-alloy steel in simulated deep-sea environments	4
Corrosion under insulation of pipeline steel in groundwater containing sulphate-reducing bacteria	4
Effects of solid deposits on the corrosion behaviour of titanium in high acidity and highly oxidising leaching solutions	4
Effect of shot blasting parameters on corrosion resistance and de-rusting effectiveness in welded zones	4
Electrochemical thermodynamics of stress corrosion of pipeline steel in active and passive environments studied by scanning Kelvin probe	4
The impact of non-uniformity and resistivity on the homogenised corrosion parameters of rebars in concrete – a circuit model analysis	4
Impact of materials deterioration and corrosion on the readiness of U.S. naval aviation	4
Corrosion-resistant coating on AZ91D magnesium alloy based on one-step hydrothermal	4