OOIR: Observatory of International Research

Papers

(The TQCC of Fuel Cells is 4. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-05-01 to 2026-05-01.)

Article	Citations
Zinc‐assisted synthesis of Fe‐N‐C catalysts based on polyaniline with high oxygen reduction reaction catalytic activities in direct methanol fuel cells	60
Energy Management System for a Multi‐Source Electric Power System Architecture in More Electric Aircraft	43
Performance Analysis of Steam‐Power Cogeneration System Based on Proton Exchange Membrane Fuel Cells	38
	28
Methods to Measure the Electrical Resistances of a Gas Diffusion Layer Under Mechanical Compression	26
Performance analysis of a natural gas‐fueled 1 kW solid oxide fuel cell‐combined heat and power system with off‐gas recirculation of anode and cathode	25
Visualizing water inside an operating proton exchange membrane fuel cell with video‐rate terahertz imaging	21
Amorphous Carbon Surface Coating of Titanium Plates Toward Corrosion Protection of Bipolar Plates in Proton Exchange Membrane Fuel Cell	18
Novel porous electrode designs for reversible solid oxide hydrogen planar cell through multi‐physics modeling	17
Thermodynamic Modeling of Hydrogen Fuel Reformers Through Gibbs Energy Minimization	15
A review of energy management optimization based on the equivalent consumption minimization strategy for fuel cell hybrid power systems	15
The Prospect and Challenge of Hydrogen Peroxide in Constructing High‐Performance pH‐Disparate Direct Liquid Fuel Cells	15
Three‐Dimensional Thermal Distribution Analysis in Direct Internal Reforming Cell‐Stacking Solid Oxide Fuel Cells Fueled by Methane/Carbon Dioxide Mixture Gas	13
Demonstration and scale‐up of high‐temperature electrolysis systems	13
	13
Self‐Humidifying Membranes Based on Amine Functionalized Tungsten Oxide and Nafion for Proton Exchange Membrane Fuel Cells Operating at Low Relative Humidity	13
Control Strategy of Flooding Avoidance With Active Humidifier System for High Performance Automotive Fuel Cell Systems	13
ANFIS–MPPT With Optimization in PEMFC‐Integrated Novel Cuk–Luo Converter Topology for Electric Vehicle Applications	12
Correction to “Performance Evaluation of Microbial Fuel Cell Using Biomass‐Derived Carbon Electrode”	12
Enhancing Proton Exchange Membrane Fuel Cell Performance With Roughened Cathode Channels and Novel Silicone Baffles	12
Performance Evaluation of Microbial Fuel Cell Using Biomass‐Derived Carbon Electrode	10
	10
Numerical Study on the Effect of the Combined Radial Flow Field on the Performance of Proton Exchange Membrane Fuel Cells	9
Microporous Layer Design for Active DMFC Using CNF‐TiO ₂ Integration to Mitigate Methanol Crossover and Improve Power Density	9
Electrochemical and microstructural characterization of the high‐entropy perovskite La_0.2Pr_0.2Nd_0.2Sm_0.2Sr_0.2CoO_3‐δ for solid oxide ce	9

	9
Elucidating the Electrochemical Impedance Spectroscopy Characteristics of PEM Fuel Cells Via A Quasi‐Two‐Dimensional Mechanism Model	9
Breaking the Alkaline HOR Barrier: Process‐Engineered Strategies for Breaking the Kinetic Bottleneck of Alkaline Hydrogen Oxidation Reaction	9
Tailoring the solid oxide fuel cell anode support composition and microstructure for low‐temperature applications	9
Microstructural changes in nickel‐ceria fuel electrodes at elevated temperature	9
	9
Spatially Resolved Current Density and Electrochemical Impedance Spectroscopy in PEM Fuel Cells	9
Cover Fuel Cells 5/2024	8
Combining Electrochemical Nitrate Reduction and Anammox for Treatment of Wastewater With Low C/N Ratio Nitrate	8
Corrosion behavior and surface structure analysis of pure aluminum immersed in fluoride‐sulfate solutions simulating polymer electrolyte membrane fuel cell‐produced water	8
Study on the nonuniform mechanical degradation of membranes considering temperature and relative humidity distribution in proton exchange membrane fuel cells	8
	8
Horned Lizard Defense Tactics Optimization Algorithm for Precise Identification of PEMFC Parameters	8
Solid oxide electrolysis stack development and upscaling	8
Effects of impurities in the cathode airflow on proton exchange membrane fuel cell stacks	8
Novel control approach for integrating water electrolyzers to renewable energy sources	8
Selective Oxidation of Glycerol to Glycolic and Oxalic Acids for Direct Glycerol Fuel Cell	8
Exploring electrochemical impedance spectroscopy to identify and quantify degradation in commercial solid oxide electrolysis stacks	7
	7
Influence of Sr Concentration and A‐Site Deficiency on the (La ₁₋ _y	7
The impact of baffle and taper channel tilt angle on the output performance of proton‐exchange membrane fuel cells	7
Phosphoric Acid Electrolyte Uptake and Retention Analysis on UiO‐66‐NH₂ Polybenzimidazole Nanocomposite Membranes	7
Cover Fuel Cells 1/2025	7
Cover Fuel Cells 1/2023	6
Chemical aging of sealing gasket of proton exchange membrane fuel cell	6
Economical and sustainable microbial peroxide‐producing cell utilizing domestic sewage water and its contemporaneous treatment	6
Nanofiber/Nanoparticle Electrodes for Ultra‐low Platinum Fuel Cells via Simultaneous Foam Electrospinning and Electrospraying	6
	6
Densification of Plasma‐Sprayed ScSZ Enables High Performance of Intermediate Temperature Solid Oxide Fuel Cells With EWSB/ScSZ Bilayer Electrolyte	6
	6
Aging Effects Observed in Automotive Fuel Cell Stacks by Applying a New Realistic Test Protocol and Humidity Control	5
Design and Performance Analysis of a Novel Gradient Flow Field Structure for Proton Exchange Membrane Fuel Cells	5
A novel advanced test system for polymer electrolyte membrane water electrolysis based on hydraulic cell compression	5
Electrochemical impedance spectroscopy studies of the buffered and non‐buffered microbial fuel cell	4
Spatial sulfur poisoning behavior associated with in‐plane electrochemical performance variation of solid oxide fuel cells	4
A Hybrid MPPT Algorithm for Fuel Cell Stack Based on Fuzzy Rules and Genetic Particle Swarm Optimization	4
Channel to rib width ratio effect on thermal performance of cooling plate in polymer electrolyte membrane fuel cell	4
Effect of membrane deposition methods on the performance of membrane electrode assemblies	4
Electrochemical Performance of Highly Oxygen‐Permeable Ba(Co,Fe,Y)O ₃ ‐Based Cathodes in Protonic Ceramic Fuel Cells	4
Research about two‐step channel with lateral narrowing structures in the flow mass transfer of proton exchange membrane fuel cell	4
	4
Stack Performance Optimization and 3.5 kW System Demonstration of Thin Metal‐Supported SOFCs Fabricated by Atmospheric Plasma Spraying	4