China Foundry

Papers
(The H4-Index of China Foundry is 13. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-11-01 to 2025-11-01.)
ArticleCitations
Phenomena at three-phase electroslag remelting30
Effect of La addition on semi-solid microstructure evolution of Mg-7Zn magnesium alloy21
A comparative study on Sn macrosegregation behavior of ternary Al-Sn-Cu alloys prepared by gravity casting and squeeze casting19
Effect of heat treatment on microstructure and mechanical properties of Ti-containing low alloy martensitic wear-resistant steel19
Structures and macrosegregation of a 2024 aluminum alloy fabricated by direct chill casting with double cooling field18
Migration behavior and aggregation mechanism of SiC particles in silicon melt during directional solidification process17
Solidification microstructure of Ti-43Al alloy by twin-roll strip casting16
Effect of pouring time on microstructure and mechanical properties of centrifugal cast Ti-46Al alloy tubes16
Effect of rare earth on morphology and dispersion of TiB2 phase in Al-Ti-B alloy refiner15
Influence of different high pressure die casting processes on 3D porosity distribution of Mg-3.0Nd-0.3Zn-0.6Zr alloy14
Effect of polysilazane on microstructure and properties of Al2O3-based ceramic core for 3D printing14
Microstructure evolution and age-hardening response in Mg-Sn-Sm alloys under a wide range of Sm/Sn ratio14
Effect of 3D printing angle on microstructure and mechanical properties of silica ceramic cores by stereolithography14
Elastic-viscoplastic constitutive equations of K439B superalloy and thermal stress simulation during casting process13
Al-CeO2-Mg refiner on grain refinement, cast fluidity and mechanical properties of AZ91 alloy13
Compression properties of cost-efficient porous expanded clay reinforced AA7075 syntactic foams fabricated by industrial-oriented die casting technology13
Positive effect of Mo on mechanical properties of a Ni-42W-10Co-xMo medium heavy alloy13
Optimizing mechanical performance and microstructural integrity in CaO-doped alumina ceramic cores by additive manufacturing13
On microstructure and room-/high-temperature properties of an Al2O3/Al-Cu-Mn composite13
Effect of V and Sn on microstructure and mechanical properties of gray cast iron13
0.029267072677612