Advances in Applied Ceramics

Papers
(The TQCC of Advances in Applied Ceramics is 3. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-04-01 to 2025-04-01.)
ArticleCitations
Rapid microwave-assisted synthesis of rare-earth hexaborides powders61
3D printing of fibre-reinforced ceramic composites with hierarchical structure15
Preparation of zirconium diboride by reduction of zirconia with calcium hexaboride10
Mechanical and thermal insulation properties of carbon fibre-reinforced carbon aerogel composites9
From stoichiometric to non-stoichiometric high-entropy carbide: A case study of hafnium addition9
Localised surface modification of high-strength aluminium–alumina metal matrix composite coatings using cold spraying and friction stir processing9
The effects of sintering additives on the ceramic matrix composite of ZrO2: microstructure, densification, and mechanical properties – a review7
Impact of Er substitution on the properties of NdFeO3: structural, magnetic and microwave absorption7
Stability of 3Y-TZP nano zirconia powder after hydrothermal ageing treatment6
Improving mechanical properties of carbon and tool steels via chromizing6
Catalytic performance of porous Yb2O3 sesquioxide6
3D-printed porous Al2O3 membrane coated with hydrophilic modified titanium dioxide particles for large-flux oil/water separation5
Fabrication and characterisation of ZrO2-reinforced porous mullite ceramics5
Preparation of high-temperature active zirconium boride powders via precursor route and microwave sintering5
Low-temperature synthesis of Ti3SiC2 powders in mixed molten salts4
Preparation and tribological performance of CrAlTiCN coatings on 316L and TC4 substrates in sea water4
Influence of sintering temperature and Li+/Mg2+ doping on the thermoelectric properties of Bi2−2xLixMgxSr2Co4
Preparation and oxidation behaviour of MoSi2-SiC-Si-ZrB2 composite coatings on carbon surface via laser cladding4
Fabrication and characterisation of ZrSi2 ceramics via reactive hot-pressing4
Pressure slip cast processing of alumina (Al2O3) products and comparative evaluation of mechanical properties4
Novel intermediate temperature solid oxide fuel cell based on La-doped Bi4V2O11 electrolyte4
Strengthen the bonding of self-glazed zirconia to enamel by sol–gel coating4
A comprehensive review of modern engineered ceramics coatings for optimised resistance to wear and corrosion4
Effect of screw access hole on the fracture load of implant-supported monolithic zirconia single crown4
Fitness of self-glazed zirconia onlays using conventional and digital impressions3
Enhanced densification and ionic conductivity of LLZO by flash sintering3
Biphasic BiFeO3 ceramics based on rhombohedral and tetragonal polymorphs3
Time dependent deformation of LaCoO3 based perovskites at different temperatures: ferroelastic and non-ferroelastic creep behaviour3
Preparation of porous mullite ceramics consisting of needle-like mullite whiskers3
Clinical application of fully digital self-glazed ultra-thin zirconia veneers3
Plant extract-based biosynthesis of silver nanoparticle and silver–zinc nanocomposites-doped hydroxyapatite and its antimicrobial activity3
0.046069860458374