OOIR: Observatory of International Research

Papers

(The H4-Index of IEEE Journal of Emerging and Selected Topics in Power Electronics is 56. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2021-09-01 to 2025-09-01.)

Article	Citations
IEEE Journal of Emerging and Selected Topics in Power Electronics Publication Information	245
Connect. Support. Inspire.	171
Table of Contents	145
Create Change: IEEE Smart Village	132
IEEE Journal of Emerging and Selected Topics in Power Electronics	132
Torque Ripple Suppression Strategy for Open-Winding PMSM With Zero-Sequence Loop Model-Free Control	124
Dead-Time Evaluation With Switching Frequency for GaN-Based Non-Inverting Buck-Boost DC–DC Converter Using FPGA-Based High-Frequency Control	118
A New Hardware Architecture for SVPWM Technique Based on the Taylor Decomposition	109
Analysis and Design of a Modular Self-Balance High-Voltage Input DC–DC Topology	105
Time-Varying Model and Boundary Model of Differential Mode Circulating Switching Harmonics Among Multiple Inverters	104
Integrating 10-kV SiC MOSFET Into Battery Energy Storage System With a Scalable Converter-Based Self-Powered Gate Driver	101
A Simple Dual Three-Level Inverter Topology With Improved Fault Tolerance	101
Adaptive Anti-Saturation Control Design of Transformers in Converter-Based Grid Emulators	101
Power Control for Grid-Connected Converter Based on Generalized Predictive Current Control	100
Modulation Coordinated Voltage Balance Strategy for a Dual-T-Type Modular Multilevel Converter	92
Operation and Efficiency Analysis of a Five-Level Single-Phase Hybrid Si/SiC Active Neutral Point Clamped Converter	89
Research on Interturn Short-Circuit Fault Indicators for Direct-Drive Permanent Magnet Synchronous Motor	88
Event-Triggered SMC-Based FRT Approach for DFIG-Based Wind Turbines Equipped With DVR With High-Frequency Isolation	86
An Improved Dead Time Compensation Method Based on Multiple Cascaded Extended State Observer for PMSM Drives	85
Per-Phase Active Power Distribution Strategy for Three-Phase Grid-Tied Inverters Under Unbalanced Conditions Without DC Sources	85
Overvoltage Suppression Scheme for Minimized Snubber Requirements in MVDC Solid-State Breakers With Series-Connected IGBTs	85
Optimization of Reflux Power in Triple Active Bridge With Online Particle Swarm Optimization and Exponential Weighted Moving Average Algorithm	84
Extension of Zero-Voltage Switching Region of Wide Volage Ratio Range Dual-Active-Bridge Converter by LC Antiresonant Network	83
Enhanced Fault Ride-Through of Power Converters Using Hybrid Grid Synchronization	82
Multiconstraint Design of Single-Switch Resonant Converters Based on Extended Impedance Method	80

Analysis and Design of 10-MHz Capacitive Power Transfer With Multiple Independent Outputs for Low-Power Portable Devices	79
High Boost Seventeen-Level Switched Capacitor Inverter Topology With Continuous Input Current	79
Nonlinear Efficiency-Optimal Model Predictive Torque Control of Induction Machines	77
Energy Management Optimization Method of Plug-In Hybrid-Electric Bus Based on Incremental Learning	76
Three-phase VIENNA Rectifier Interval Control Strategy to Improve Light Load Performance	76
A Multistep Charge Extractions and Voltage Bias-Flip (MCEBF) Interface Circuit for Piezoelectric Energy Harvesting Enhancement	75
Design and Analysis of Quadratic Buck Converter Based on the Reduced Redundant Power Processing	73
Dynamic Voltage Restorer with Integration of Least Mean Square and Optimal Type-2 Fuzzy	73
Fault-Tolerant Operation of the DC/DC Modular Multilevel Converter Under Submodule Failure	72
A Hybrid Pulse Frequency Modulation Control Strategy for L-LLC Resonant Converter	72
Enhanced Anti-Disturbance Capability of Digital Controller for the SPMSM at Low Switching to Fundamental Frequency Ratios	67
Dissipativity Enhancement for Multisampled LCL-Type Inverter Using a Low-Delay Ripple-Removal Method	67
A Fast Data-Driven Method for Submodule Open-Circuit Fault Localization in a Modular Multilevel Converter	66
Research on AC Microgrid With Current-Limiting Ability Using Power-State Equation and Improved Lyapunov-Function Method	65
Model-Free Sequential Predictive Control for MMC With Variable Candidate Set	65
Speed Synchronization Control Strategy of Dual-Motor System With Explicit Model Predictive Control	64
Modeling and Suppression of Zero-Sequence Circulating Current Resonance for Parallel Interleaved Inverters With Bypass Capacitor-Based Leakage Current Mitigation	63
Research on Active Thermal Control: Actual Status and Future Trends	63
On Converter Fault Tolerance in MMC-HVDC Systems: A Comprehensive Survey	62
Coupled-Inductor-Based Dual Active Bridge Converter With Soft Switching Capability and Low Component Count	62
A Multiload Parity-Time Symmetric Wireless Power Transmission System Inspired by Non-Hermitian Physics	61
A Novel LED Driver With Enhanced Efficiency Using a Buck–Boost Converter and DC–DC Buck Converter	61
Comprehensive Investigations on Recovery Characteristics of Bias Temperature Instability in Planar and Trench SiC MOSFETs	60
Multisector Three-Phase PMSM Drive System With Low-Frequency and High-Frequency PWM Noise	60
A Novel Current Sharing Scheme for Multiphase Interleaved LLC Converter Based on Partial Energy Regulation of Resonant Capacitor	60
High-Fidelity Reduced Order Modeling Approach for Medium-Voltage Drives and Artificial Intelligence Capable Systems	60
Comprehensive Comparative Assessment of Multiphase Overmodulation Techniques and Three-Phase Discontinuous PWM Methods Applied to Symmetrical Six-Phase Induction Motor Drives Under Overmodulation	60
Design and Validation of an Unconventional 39-Slot PM Synchronous Motor With Asymmetric and Unbalanced AC Windings	59
Design of Compact Solid-State Modulator for High-Power Electromagnetic Pulse Generation	58
Research on Armature Winding Characteristic of a Double Rotor Permanent Magnet Motor From Perspective of the Magnetic-Field Modulation	56
Inertia Evaluation and Optimal Design for PMSG-Based Wind Turbines With df/dt Control	56