OOIR: Observatory of International Research

Papers

(The H4-Index of Journal of Energy Storage is 121. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2022-01-01 to 2026-01-01.)

Article	Citations
Modeling of solidification via Galerkin method within storage unit utilizing nano-powders incorporating unsteady source term	401
Editor's note for article entitled “Prediction of experimental thermal performance of new designed cold plate for electric vehicles' Li-ion pouch-type battery with artificial neural network”	397
Improving the solar-to-thermal conversion efficiency of bio-based balsawood/octadecane phase change composites via surface carbonization	388
Editorial note for “Phosphorene polymeric nanocomposites for electrochemical energy storage applications” [J. Energy Storage 69 (2023) 107940]	385
Editorial Board	376
Editorial Board	348
Editorial Board	345
Expression of Concern for article entitled “Assessment of the effect of distance between lithium-ion batteries with a number of triangular blades, on the thermal management of the battery pack in a ch	325
Expression of Concern for article entitled “Combining an active method and a passive method in cooling lithium-ion batteries and using the generated heat in heating a residential unit”	305
Techno-economic-environmental analysis of hybrid renewable energy system with lead acid and lithium-ion energy storage under different PV tracking orientations	299
Bypass control strategies for the rated total output power of compressed air energy storage system	291
Lithium-exchanged molecular sieve-functionalized liquid crystal elastomer solid-state electrolyte for high-performance lithium metal batteries	275
Atmospheric stability enhancement of borohydride-substituted sulfide solid electrolytes via porous silica incorporation	274
Experimental and theoretical study on the rate of melting of phase change material upon heating	274
Novel equivalent circuit battery model with adaptive parameters for hybrid state of charge estimation	269
Mesoporous spherical Ni(OH)2@g-C3N4 hybrid heterostructures with amorphous shell as battery-type capacitive cathodes for enabling high-performance hybrid supercapacitors	262
Expression of Concern for article entitled “Investigation of the use of extended surfaces in paraffin wax phase change material in thermal management of a cylindrical lithium-ion battery: Applicable i	253
Real-time outdoor experiment and performance analysis of dual-coil heat exchanger integrated thermal energy storage	247
Conditional scenario-based energy management algorithm with uncertain correlated forecasts	245
A new state of charge prediction method for electric vehicles by an attention-based SAE-BiLSTM model: Analyzing driving styles and vehicle types with operational and environmental data	241
A review of salt mechanical behavior, stability and site selection of underground hydrogen storage in salt cavern-Moroccan case	235
Acceleration of heat discharge of composite lauric acid using magnetic dopant	235
Enhancing battery health estimation using model selection criteria-based genetic programming	227
CuGa2 transition phase anchored liquid GaSn achieves high-performance liquid metal battery cathode	225
Rechargeable non-aqueous lithium-O2 batteries: Novel bimetallic (Ni-Cu) conductive coordination polymer cathodes	222

High-performance S cathode through a decoupled ion-transport mechanism	221
Wind-storage combined system based on just-in-time-learning prediction model with dynamic error compensation	220
MXene-based ternary composites for supercapacitors: Advancements and challenges	216
High-performance shape-stabilized phase change material modified by bio-based nano porous graphene for electro-to-thermal and solar-to-thermal conversion and storage	215
Thermal runaway properties of power cells under tunnel scenarios: Impact of heating patterns and heating powers	214
A variable-frequency self-heating strategy for lithium-ion batteries based on an electrochemical impedance-thermal coupling model applicable to a wide frequency range	207
The intellectual property enabling gigafactory battery cell production: An in-depth analysis of international patenting trends	202
A multichambered carbon based electrode materials to realize efficient sodium-ion batteries	197
Rotary Heat Recovery Wheel (RHRW) system with an embedded PCM: Proof of concept	197
Multifunctional polymer electrolyte membrane networks for energy storage via ion-dipole complexation in lithium metal battery	195
Combining an active method and a passive method in cooling lithium-ion batteries and using the generated heat in heating a residential unit	195
Multiscale structural engineering of Co0.85Se@porous carbon composite enables highly reversible lithium/sodium storage	195
Optimal selection of energy storage system sharing schemes in industrial parks considering battery degradation	194
Quantification of concentration characteristics of hydrogen leakage in electro-hydrogen coupled system with different obstacles via Background Oriented Schlieren	193
Effect of processing on microstructure and mechanical properties of pentaglycerine based solid-solid phase change materials	192
Construction and validation of ternary positive dry electrode simulation system	186
Nitrogen-modified spherical porous carbon derived from aluminum-based metal-organic frameworks as activation-free materials for supercapacitors	186
Simulating the uneven temperature distributions within large-sized lithium-ion batteries using a thermal resistance network model	186
Corrigendum to “Temperature optimization for enhancing the electrochemical performance of covalent triazine frameworks composite with Nb-based Mxene in asymmetric supercapacitors and hydrogen producti	185
Corrigendum to “Nickel-cobalt spinel-based oxygen evolution electrode for zinc-air flow battery” [J. Energy Storage 115 (2025) 115835–115848]	180
Hydrogen storage potential of unlined granite rock caverns: Experimental and numerical investigations on geochemical interactions	176
Editor's Note for article entitled “Role of natural convection and battery arrangement for phase change material based battery thermal management unit”	174
Enhancing electrochemical performance of asymmetric supercapacitors via heterojunction engineering of zeolitic imidazolate framework-derived cobalt oxide and bismuth oxide	174
Assessment of sector-coupling technologies in combination with battery energy storage systems for frequency containment reserve	173
Expression of Concern for article entitled “Battery thermal management systems based on nanofluids for electric vehicles”	171
2D Si@SiOx derived from Si Ca alloy and ZnO via a solid state reaction for lithium ion batteries	168
A low-cost coil alignment system for electric vehicle inductive wireless chargers	166
Harnessing sustainable energy: Synthesizing a trinary chalcogenide semiconductor BaS:Sb2S3:CuS for enhanced performance in supercapacitor devices and electro-catalysis	165
Polycarboxylic polyester binders from renewable feedstock for high-performance battery electrodes	163
The higher the better? Thermal stability and electrochemical properties of Cl-rich lithium argyrodite solid state electrolyte	160
Hydrangea-like SnS2/SnO2 heterostructure and voltage control for high capacity and stable lithium ion battery	160
Research on vanadium-chromium oxide Lithium-sulfur battery cathode materials derived from metal-organic frameworks on reduced graphene oxide aerogels	157
A novel approach to modeling and experimenting a solar-fed H6 configuration for battery swapping stations in rural and commercial areas using a dual phase CLLC DC–DC resonant converter	157
Design of an adaptive PDE boundary observer for a PEV fleet in V2G application	157
A novel peak current mode phase-shift controller for green hydrogen energy storage systems using type-3 voltage loop compensator and overcurrent protection	156
A novel fusion method for inconsistency evaluation of electric vehicle lithium-ion batteries	155
Battery sizing of 48 V plug-in hybrids considering calendar and cycle degradation	155
Investigating the synergistic effects of NbCo-oxide composite electrodes in supercapacitor and water splitting applications via hydrothermal synthesis	154
Molten salt method derived porous carbon with high energy density in KI-additive electrolyte	154
Graphene aerogel based positive electrode for lithium ion batteries	153
Stress analysis of cyclic sorption-desorption in metal hydride vessels	153
Long-term optimal planning for renewable based distributed generators and battery energy storage systems toward enhancement of green energy penetration	151
Predicting supercooling of water for large-scale volumes using differential scanning calorimetry data	150
Environmental and economic analysis of sector-coupling battery energy storage systems used for frequency containment reserve	150
Nanostructured F-TiO2/SiC with the heterojunction and oxygen vacancy defects to enhance synergistically its electrochemical charge storage performance	149
Alternating current losses in superconducting circular/stacked coils used in energy storage systems	147
Optimal power tracking for autonomous demand side management of electric vehicles	146
Heat transfer and storage characteristics of a hexagonal close structured packed-bed thermal storage system with molten salt phase change materials	146
Towards ultra-wide voltage window (3.2 V) aqueous symmetric supercapacitors triggered by hybridizing FeNiCo oxides with Ni(pyrithione)2 on FeNi foam	146
π-Conjugated electrochemically stable covalent quinazoline network for lithium ion storage	146

Preparation, microstructural characteristics, and electrochemical properties of cobalt molybdate nanocomposites as electrode material for hydrogen storage	145
Temperature-dependent effects of calcium nitrate addition and sodium/potassium ratio on the thermal stability of molten salts	144
Recycling of anode active material from spent Li-ion batteries	144
Demonstration of sector-coupling based on advanced Thermal Energy Storage: a Model Predictive Control framework for load-shifting and grid-balancing	144
Experimental investigation of an alternative battery pack thermal management system	142
Numerical optimization of lithium-ion cell performance using metaheuristic algorithms	141
German atlas of Thermal Storage Power Plants (TSPP) - A first approach	140
Activated carbon derived from Satureja seed biomass for improving the capacitive performance of composite based on Aprepitant functionalized graphene oxide and ionic liquid	139
Cleaner production of energy and fuels from a renewable energy-based self-sufficient system with energy storage options	139
Heat transfer analysis of sewer system and its potential role in thermal energy storage	139
Battery energy storage systems' integration in Baja California Sur, Mexico: A long-term electrical grid assessment	138
Facile, catalyst-free, and high enthalpy PEG-based phase change composite for use in photothermal conversion and waste heat recovery	138
Enhancing solar thermal collector systems for hot water production through machine learning-driven multi-objective optimization with phase change material (PCM)	138
A facile procedure to improve the performance of food-waste-derived carbons in sodium-ion batteries	137
Experimental investigation on the unsteady flow fluctuation of a vertical pipe inlet/outlet of the pumped storage power station	136
Electronic and structural disorder of NiCo2O4 nanostructures using phytochemicals from desert gourd offered efficient asymmetric supercapacitor and oxygen evolution reaction	136
An efficient state-of-health estimation method for lithium-ion batteries based on feature-importance ranking strategy and PSO-GRNN algorithm	135
Manganese fluoride as non-battery type anode for high performance Li-ion capacitors	134
A novel computational model and OpenFOAM solver for simulating thermal energy storages based on granular phase change materials: Advantages and applicability	134
A reduced order model for a lithium-ion 3D pouch battery for coupled thermal-electrochemical analysis	134
Mechanical modelling approach for the simulation of solid-state electrolytes	133
The effects of cell configuration and scaling factors on constant current discharge and dynamic charge acceptance in lead-acid batteries	132
Preparation of highly efficient thermal management polyurethane foam coatings based on crosslinked modified phase change microcapsules: Integration of temperature regulation, flame retardancy, and ant	130
Experimental and modeling investigation of critical slugging behavior in marine compressed gas energy storage systems	130
Melting control of phase change material of semi-cylinders inside a horizontal baffled channel: Convective laminar fluid–structure interaction	129
Coordinated self-tuning frequency support control strategy for wind turbine and energy storage battery against time-varying operating conditions	129
Shipboard applications of heat pumps and thermal energy storage under dual carbon targets: Opportunities and challenges	129
Three-dimensional MoS2/CNFs@C composites as anode materials for high-performance lithium-ion batteries	129
An experimental study on thermal runaway propagation over cyclic aging lithium-ion battery modules with different electrical connections	128
Strain analysis and non-destructive monitoring of the two-stage hydraulic-driven piston compressor for hydrogen storage	128
Fluorine-containing soluble polyimide binder improves the cycling performance of Si/C anode in lithium batteries	128
Smart thermal phase change materials with switchable morphology	128
State of health estimation embedded with hardware accelerator based on long short-term memory combined with Bayesian optimization considering extracted health indicator in charging conditions	127
Optimization of a silicon-based microencapsulation technology of phase change material without organic solvents	126
Battery state prediction through hybrid modeling: Integrating neural networks with a single particle model	126
Lifetime prediction of lithium-ion capacitors using electro-thermal-aging co-simulation platform	126
Room-temperature synthesis of ZnO-based quantum dots for enhanced electron/ion transport in ultra-stable hybrid supercapacitors	125
Investigation of La2FeO4-rGO nanocomposite electrode material for symmetric and asymmetric supercapacitor	125
Flexible carbon nanofibers with multichannel and porous structure as freestanding anode for excellent sodium storage	125
Enhanced Zn2+ transfer kinetics and desolvation through a versatile silicon carbide ceramic coating for stable Zn anode in zinc-ion hybrid capacitors	124
Study on heat storage and release characteristics of a novel phase-change thermal energy storage device using microchannel parallel-flow flat pipes	124
Superior energy storage performance of metastable β-Bi2O3 nanostructured electrode for advanced supercapacitor applications	124
A two-level decentralized model for leveraging demand-side flexibility in renewable-based power systems with energy storage assets and electric vehicle fleets	123
Triethanolamine-modified binder with synergistic effects on Zn anode in improving the cycling stability of aqueous rechargeable Zn Ni batteries	123
Effect of Aluminium (Al)-doping on electrochemical performance of hydrothermally synthesized hematite (α-Al Fe2−O3) nanospheres for supercapacitor application	123
KCl and thiourea-assisted pore formation and doping in chitosan-derived porous carbon for enhanced supercapacitor performance	121
Role of desalinated seawater groundwater recharge for seasonal energy storage	121