OOIR: Observatory of International Research

Papers

(The H4-Index of Surfaces and Interfaces is 43. The table below lists those papers that are above that threshold based on CrossRef citation counts [max. 250 papers]. The publications cover those that have been published in the past four years, i.e., from 2020-04-01 to 2024-04-01.)

Article	Citations
Studies of MnO2/g-C3N4 hetrostructure efficient of visible light photocatalyst for pollutants degradation by sol-gel technique	105
Dynamics of ternary-hybrid nanofluid subject to magnetic flux density and heat source or sink on a convectively heated surface	102
Thermophoretic particle deposition in time-dependent flow of hybrid nanofluid over rotating and vertically upward/ downward moving disk	98
Highly efficient and rapid removal of a toxic dye: Adsorption kinetics, isotherm, and mechanism studies on functionalized multiwalled carbon nanotubes	96
Recently Emerging Nanotechnological Advancements in Polymer Nanocomposite Coatings for Anti-corrosion, Anti-fouling and Self-healing	87
Fabrication of sulfur-doped biochar derived from tapioca peel waste with superior adsorption performance for the removal of Malachite green and Rhodamine B dyes	83
Understanding interfacial influence on properties of polymer nanocomposites	82
Ultra-thin silver nanoparticles film prepared via pulsed laser deposition: Synthesis, characterization, and its catalytic activity on reduction of 4-nitrophenol	82
Insight into the motion of water conveying three kinds of nanoparticles shapes on a horizontal surface: Significance of thermo-migration and Brownian motion	80
Insights into the modeling, characterization and adsorption performance of mesoporous activated carbon from corn cob residue via microwave-assisted H3PO4 activation	76
A simple and efficient voltammetric sensor for dopamine determination based on ZnO nanorods/electro-reduced graphene oxide composite	71
Corrosion inhibition efficiency of bronopol on aluminium in 0.5 M HCl solution: Insights from experimental and quantum chemical studies	67
Synthesis of pyrolyzed biochar and its application for dye removal: Batch, kinetic and isotherm with linear and non-linear mathematical analysis	67
Uptake of anionic and cationic dyes from water using natural clay and clay/starch/MnFe2O4 magnetic nanocomposite	66
Recent advances in TiO2-functionalized textile surfaces	63
Wettability Transition for Laser Textured Surfaces: A Comprehensive Review	62
Hot corrosion behavior of plasma-sprayed NiCrAlY/TiO2 and NiCrAlY/Cr2O3/YSZ cermets coatings on alloy steel	61
Quinoline and its derivatives as corrosion inhibitors: A review	60
Influence of the alkyl chain length of surfactant on adsorption process: A case study	59
Neuro-computing networks for entropy generation under the influence of MHD and thermal radiation	59
Bioconvection assessment in Maxwell nanofluid configured by a Riga surface with nonlinear thermal radiation and activation energy	59
Heterointerface engineering of water stable ZIF-8@ZIF-67: Adsorption of rhodamine B from water	58
Averrhoe carrambola fruit extract assisted green synthesis of zno nanoparticles for the photodegradation of congo red dye	56
Preparation and characterization of Vanadium pentoxide (V2O5) for photocatalytic degradation of monoazo and diazo dyes	56
H2SO4-treated Malaysian low rank coal for methylene blue dye decolourization and cod reduction: Optimization of adsorption and mechanism study	55

Green synthesis of nickel oxide nanoparticles using Solanum trilobatum extract for cytotoxicity, antibacterial and photocatalytic studies	55
A comparative study of photocatalytic degradation of Rhodamine B using natural-based zeolite composites	54
Synthesis and characterization of TiO2 doped cobalt ferrite nanoparticles via microwave method: Investigation of photocatalytic performance of congo red degradation dye	53
Enrichment of the surface functional groups of activated carbon by modification method	50
Recent progress of PM6:Y6-based high efficiency organic solar cells	50
Crosslinked carboxymethyl cellulose-hydroxyethyl cellulose hydrogel films for adsorption of cadmium and methylene blue from aqueous solutions	48
Combined experimental thin films, TDDFT-DFT theoretical method, and spin effect on [PEG-H2O/ZrO2+MgO]h hybrid nanofluid flow with higher chemical rate	48
Emerging trends in polymer aerogel nanoarchitectures, surfaces, interfaces and applications	47
Insight into adsorption mechanism of Congo red dye onto Bombax Buonopozense bark Activated-carbon using Central composite design and DFT studies	47
A thermodynamic and kinetic approach to adsorption of methyl orange from aqueous solution using a low cost activated carbon prepared from Vitis vinifera L.	47
The effects of nano- and micro-particles on properties of plasma electrolytic oxidation (PEO) coatings applied on titanium substrates: A review	46
Structural characterization of green synthesized α-Fe2O3 nanoparticles using the leaf extract of Spondias dulcis	46
Structure design and properties investigation of Bi2O2Se/graphene van der Waals heterojunction from first-principles study	46
Study of Brownian motion and thermophoretic diffusion on non-linear mixed convection flow of Carreau nanofluid subject to variable properties	46
New Promising Ceramic Coatings for Corrosion and Wear Protection of Steels: A Review	45
Perceptive removal of toxic azo dyes from water using magnetic Fe3O4 reinforced graphene oxide–carboxymethyl cellulose recyclable composite: Adsorption investigation of parametric studies and their me	44
The effects of carbon-based additives on corrosion and wear properties of Plasma electrolytic oxidation (PEO) coatings applied on Aluminum and its alloys: A review	44
Structural, optical and thermoelectric properties of Al-doped ZnO thin films prepared by spray pyrolysis	43
A comparative study between linear and exponential stretching sheet with double stratification of a rotating Maxwell nanofluid flow	43